Why are my RV leveling jacks not working?

Of course, the overarching concern here is that hydraulic systems like RV leveling jacks are intended to be a sealed system. If the hydraulic fluid is suddenly low, it must be coming out of somewhere.

Why does my self leveling valve stop working?

As oil drains from the lift side of the bucket tilt cylinders through port D, the pressure on port C will drop, causing the spool to slide right and stop oil flowing in port D. In my case, the problem was a missing retaining ring (#1) on the left side of the spool (#4).

Can a hydraulic fluid leak from a level Jack?

Hydraulic fluid leaks are not an uncommon problem with level jack malfunctions. In a few rare cases, the hydraulic fluid might below. If you are particularly handy, you might be able to simply top it up yourself. Otherwise, this is something that you really should leave to the professionals.

Where does the oil go in a self leveling valve?

In the middle of the valve is a flow divider. As oil comes in port B, some oil goes through a needle valve on the right (#5) and some goes to the center land on the flow divider spool (#3). The oil going into the flow divider spool can only go to the left towards the A port.

How to troubleshoot RV hydraulic leveling jacks?

Walk around the RV and put eyes on each of the jacks to determine if there are any obvious issues preventing you from getting the jacks retracted. Look closely to see if there is any hydraulic fluid leaking anywhere as well.

What should I do if my hydraulic system is not working?

Hydraulic systems dissipate heat through the reservoir. Therefore, the reservoir fluid level should be monitored and maintained at the correct level. Check that there are no obstructions to airflow around the reservoir, such as a build up of dirt or debris. It is important to inspect the heat exchanger and ensure that the core is not blocked.

What happens when you press the button on a leveling jack?

Nothing can create that sinking feeling in your stomach quite like pressing the button to operate your leveling jacks and having nothing happen. That can make for a bad start to a trip or it can provide a terrible ending to an otherwise fun getaway. Whether your jacks are stuck up or down can make a big difference in the criticality of the fix.

What kind of fluid do you use for leveling jacks?

Hello Joe, Typically Fleetwood used the Power Gear leveling system which is now owned by Lippert Components Inc (LCI). According to the Power Gear manual, they recommend the following: Type A automatic transmission fluid (ATF, Dexron III, etc.,)will work satisfactorily.

Do you need to auto level your RV?

Using the Auto Leveling System. If your RV has an auto-leveling system, then you don’t need to worry about as many factors of leveling an RV, as the system will do it for you. Generally, once you park, you can press the auto-leveling button, and everything will adjust as necessary.

How do you know if your RV freezer is level?

Bill mentioned in the video that if you’re concerned about how level your rig is, you could use a simple bubble level to ensure you’re ‘level enough’. Place the bubble level on the freezer plate inside the freezer, and check the level once you park and stabilize your rig. Try to keep half of the bubble in the center circle at all times.

Is there a problem with Lippert leveling jacks?

The following questions and examples can help you troubleshoot a problem with sometimes more complicated Lippert Systems leveling jacks. Time out errors is not uncommon with malfunctions that apply excess force on the system.

Why does my Lippert LCI leveling system not work?

My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks.

What should I do if my leveling jacks keep freezing?

If you notice water starting to poll around your leveling jacks and the upcoming forecast calls for temperatures to dip below 32 degrees Fahrenheit, you might want to take steps to prevent the puddle from freezing. Adding simple rock salt to the puddle will lower its freezing point.

My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks.

Can you drive a RV with the Jacks down?

You cannot move or drive the RV with the jacks down, so you have to get this fixed right away. You will likely be under a time crunch as someone else may be scheduled to camp in that same spot later in the day. First, if you are scheduled to check out that day, you should notify the campground office of your issue.

How do you retract hydraulic jacks on an RV?

These systems typically have a manual override that will allow you to retract the jacks in order to get your rig to a repair shop. This usually involves opening the manual release valve and then manually prying the jacks up. If you make it to this step, be sure you take all proper precautions to avoid injury.

What to do if your jacks are stuck up or down?

Whether your jacks are stuck up or down can make a big difference in the criticality of the fix. If you are in a motorhome and your jacks are stuck in the raised position and will not lower, this will not necessarily ruin your trip. Obviously, you will want to address the issue as soon as possible and get things corrected.

Why are the jacks on my RV not working?

One particular user who emailed in about this issue said they had cleaned and oil their hydraulic system, but the growling problem still persisted. Growling typically means there’s corrosion somewhere in your hydraulic system, likely in the shafts, and each manufacturer has its own recommendations for troubleshooting this issue.

What happens when leveling jacks don’t Retract?

When this happens you can’t safely move the RV, and you’re essentially stuck at your campground or RV park. If the leveling jacks won’t retract there are several things that can cause a problem with an RV’s leveling jacks.

What happens if your jacks are stuck in the raised position?

If you are in a motorhome and your jacks are stuck in the raised position and will not lower, this will not necessarily ruin your trip. Obviously, you will want to address the issue as soon as possible and get things corrected.

How does a power gear leveling system work?

Unlike the hydraulic systems, their air-hydraulic counterparts allow for leveling a vehicle in motion, using the air leveling method only. More commonly, automatic or manual leveling is achieved through the use of four Power Gear leveling jacks that firmly stand on the ground when the RV is parked.

Is there a company that makes RV leveling systems?

In 2014, the company became part of Lippert Components, one of the global leaders that supplies a range of products for the RV industry and owns numerous brands and production facilities in the United States, Canada, and several European countries. All Power Gear leveling systems can be divided into the hydraulic and electric ones.

Why does my RV have a low voltage?

With some mechanical systems, low voltage can be a problem. In some cases, where onboard power is particularly low, a display panel or warning light might trip where there isn’t anything technically wrong with the system. If you have been having an electrical issue, a bad battery, you might be suspicious of a power problem.

Why does my RV leveling system not work?

RV Leveling system responds to the designated built-in switch that it comes with. It may get damaged between your trips. If that’s the case you need to replace the switch as soon as possible. The leveling system will not work without the switch. Lippert Components Power Switch comes to rescue you from that hassle.

What kind of leveling system does a Winnebago Brave have?

Have a 2004 Winnebago Brave with the HWH 325 series Leveling System. While driving the yellow ‘Jacks Down’ indicator light turned on and buzzer sounded, pulled over and found the LR jack was down about 1/4 inch with the round RF jack indicator on the keypad was ‘red’.

What are the valves for front and rear leveling jacks?

With these motorized units, the two center valves are responsible for controlling the front jacks. You will need to open the center valves very slowly. Once the front jacks are retracted, you can then slowly open the valves controlling the outer rear jacks.

What was the recall on the Fleetwood Bounder?

The mounting screws for the satellite dish may not have been fastened through the sheet steel reinforcement, possibly allowing the satellite dish to detach from the roof while driving. Recall Details

What should the voltage of a motor be to not overheat?

To run properly and not overheat, the motor should run at 55 to 60 percent of the total voltage capacity. Author: Gary Jouas – Evaporative cooling is actually a complicated phenomenon dependent upon air and water temperature, air-flow and humidity or the amount of water that already exists in the air.

What causes an electric motor to stop working?

Low resistance is the most common reason behind electric motor failure. Degradation of motor windings by heat will pave the way for short-circuits and leakages, which leave the motor at risk for failure.

What are the flashing lights on my Atwood levelegs?

Periodically, especially if the rig has been sitting for a while, my Atwood Levelegs electric jacks will refuse to retract and will display flashing green and red lights, usually in one corner, indicating which jack is having trouble.

What to do if your levelegs control unit Won’t Shut Up?

If the jacks are retracted fully and the control unit won’t shut up, you can unplug the jack on the back of the control unit and drive without the distraction — just make very sure that you’ve visually inspected all the jacks to make certain that they are fully retracted before going anywhere.

What should I do if my leveling jacks are not working?

Silicones and cleaning agents such as Dawn dish soap can worsen the corrosion and render your system irreparable. So what you should do is spray the system well with WD-40 and then wipe clean.

Are there hydraulic leveling jacks on my 2006 Seabreeze?

On our last trip, Dec 2018 with my 2006 National SeaBreeze LX 32′, the hydraulic leveling jacks deployed correctly, but upon leaving they retracted normally, but slow, and then the control panel displayed at least one of them was still down and would sound an alarm when I removed the parking brake.

Why do I need to calibrate my leveling jacks?

A light will come on if that side of the unit is lower than the others. The lights work the exact same way as the four lights on the dashboard leveling controls. When all four lights are out, the unit is level. The need for calibration arises because the motorhome’s jacks extend until the calibration unit is level.

Where are the leveling jacks on a HWH?

There are three screws on the bottom corners attached to three springs (see yellow arrows in the photo below). These correspond to three of the four leveling jacks under the motorhome. Tightening or loosening these springs will tilt the calibration unit, with the goal being to make the unit just as level as the motorhome.

What to do if your leveling jack wont extend?

To help you troubleshoot the situation and find the right solution, RVing expert Dave Solberg teaches you how to diagnose a faulty leveling jack system. You’ll learn what to do to safely inspect your fluid reservoir and valves, and discover the most common reason RV jacks won’t extend.

Is there a problem with the Jacks down alarm?

We have been having a problem with the jacks down alarm. This happened as we were driving down the interstate a couple of years ago. The jacks were up but the alarm kept sounding. The dealer said that everything was fine and we didn’t have any further problem until now. We retract the jacks and visually they seem to be all the way up.

How does an automatic leveling system work on a RV?

The patented six-point Level Up® hydraulic leveling system levels an RV in less than a minute using a one-touch auto-leveling feature, and includes an auto re-hitch memory function that remembers the exact height at which the RV was unhitched.

How does uneven ground affect a leveling system?

Uneven ground can cause a lot of problems and other leveling systems can stress and twist the chassis, damaging slide systems, sidewalls and windows.

How does Ground Control 3.0 Power leveling system work?

Available in both 4-point and 6-point configurations, the Ground Control 3.0 power leveling system uses Hall Effect technology to efficiently and accurately level your RV by measuring the motor revolutions of your jack’s legs, instead of amps.

What to do if your hydraulic jack stops working?

Hydraulic jack works on fluid that pushes through tubes by a motor. If there’s a problem with the motor, your jacks are likely to stop working. To see if your motor has a problem, Untether the power connection from the motor and use new wire from the battery to eliminate faulty cable issues.

Why does my hydraulic system on my RV not work?

We’re not sure about other types of RVs. One symptom is very slow or sluggish system (jacks and slides). Sometimes it will start out fine then slow down to a crawl and possibly stop. Another symptom is that the jacks or slides just don’t operate at all. The system appears to be fine. All the lights are normal, but just don’t DO anything.

What kind of transmission fluid does Mick Fleetwood use?

Typically Fleetwood used the Power Gear leveling system which is now owned by Lippert Components Inc (LCI). According to the Power Gear manual, they recommend the following: Type A automatic transmission fluid (ATF, Dexron III, etc.,)will work satisfactorily.

What should I do if my spring release Jacks wont retract?

With spring release and power retract systems there is usually a manual release valve for each jack. First, you need to find the hydraulic control unit. Also double-check to make sure no people, pets or belongings are under the RV.

Why does my 5th wheel hydraulic system slow down?

Note: This issue seems to be common on 5th wheels with hydraulic leveling systems. We’re not sure about other types of RVs. One symptom is very slow or sluggish system (jacks and slides). Sometimes it will start out fine then slow down to a crawl and possibly stop.