Why are my lights not working in my RV?
Lots of things can go wrong with your RV ceiling lights, preventing them from working. It could be an issue with the GFI or the circuit breaker if you use a 110AC system. You could also run into trouble with the fixture itself, its battery, a ballast, or the fixture’s wiring.
Where Is My RV converter?
The most common spot to find your converter is near your control panel. You will likely see a small vent or fan near your control panel that is an obvious sign that your converter is near. Whenever you buy a new or used trailer, it is essential to know how your RVs power works.
Is there an electrical problem with the slide out?
Finding an apparent electrical button, the control panel was removed and the wires for the stuck slide were placed on another slide “in/out” button. Again, there was no power to the stuck slide when the “In” was pushed. The two young mobile repair techs were now perplexed and did not have the skill to trouble-shoot the electrical issue.
Why is my slide out not working on my car?
To get back home to Katy, the power supply wires to the motor were “reversed” so the slide could be retracted so I could drive home to Katy, TX. With the power supply wires “reversed”, the slide will now not extend.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
Are there two relays for the slideroom motor?
Missing a circuit to supply power to slideroom motor.The drawing pictures one relay to power the in and out voltage to the motor- there are 2 power relays.
Finding an apparent electrical button, the control panel was removed and the wires for the stuck slide were placed on another slide “in/out” button. Again, there was no power to the stuck slide when the “In” was pushed. The two young mobile repair techs were now perplexed and did not have the skill to trouble-shoot the electrical issue.
To get back home to Katy, the power supply wires to the motor were “reversed” so the slide could be retracted so I could drive home to Katy, TX. With the power supply wires “reversed”, the slide will now not extend.
What to do if some of your 12V lights stop working?
So there we were with three of our RV 12v lights not working. The first thing we noticed was all the other lights were working fine. Some light fixtures within an RV can have switches located on a control panel. For instance, the light fixture above our sofa has a switch near the steps, this is also where our 12v on/off switch is located.
Why are some of my RV 12V lights not working?
In this instance it was as simple as replacing the fuses that had blown. But it’s important to note fuses blow for a reason. Luckily for us this time it was just because some wires had crossed. If you notice a fuse continues to blow it’s important to dig a bit deeper to find the cause.
