Where was the first arrow pump and supply?
In 1971, the first Arrow Pump & Supply location was purchased in Ada, OK, and five years later in 1976, with two employees we expanded our operations to Seminole, OK. Over the years Arrow Pump & Supply held strong through the ups and downs of the ever changing oilfield market and we continued expansion to Stroud, OK.
When did Arrow pump and supply move to Seminole?
In June 2008, Arrow Pump & Supply of Seminole moved from their beloved Main Street location of over 30 years to a new Corporate Office that houses all of our marketing and accounting offices as well as a supply store, pipe yard and pump shop.
Where is the witness mark on an Audi A4 water pump?
There are two clips holding the upper cover to the head (red arrows); unclip them and pull the cover up and away from the front of the motor. You can now remove the upper cover (red arrow). The lower cover contains the witness mark for lining the crankshaft up at Top Dead Center or TDC (yellow arrow).
Where to put dampener on Audi A4 B6 water pump?
The dampener has a locating hole (red arrow) that corresponds with a nipple in the crank (yellow arrow); this insures that the dampener can only be installed one way ensuring proper alignment with the TDC markings. Use a 19mm socket and remove the five 10mm bolts holding the lower timing cover in place.
What are the signs of a sewage pump problem?
You should especially be mindful of clanging or banging noises, which typically indicate either a problem with the overall mechanics of the pump or with its structure and integrity. However, any sounds that you don’t recognize or are not accustomed to should be cause for concern and action.
What does the notice of funding availability ( NOFA ) mean?
Notice of Funding Availability (NOFA) – The Notice of Funding Availability (NOFA) is a notice published each year in Grants.gov for HUD’s Discretionary Funding Programs. This notice describes the type of funding available on a competitive basis and provides a contact where an application may be submitted,…
When to call a plumber for a sewage pump?
However, if you have a major backup of effluent and the pump is running continuously for a long time, it is best to shut off the pump and call a plumber because you likely have an obstruction in your sewage discharge lines.
Why is the float switch on my sewage pump not working?
The continuous power supply causes the pump’s motor to run nonstop. Therefore, the pump will burn out faster than it should if left connected to direct power. Instead, you should troubleshoot the float switch and find out why it’s not functioning. A few of the most common reasons a float switch will stop working include:
