Where to plug in 12V trailer tow battery?
If yours are empty like mine were, go get two relays and plug them in. Then get a 30A Maxi Fuse and plug it into position 16 in the under hood fuse box. 16=Trailer Tow Battery Charge. This should give you power to your orange wire (switched 12v) on your 7 pin trailer harness.
What to do if your 12 volt battery is not charging?
With the shore cord plugged in take a VDC reading at the battery to see if it is charging. It should be about 13.6 VDC or so. Unplug the power source and then take a reading at the outgoing leads from the fuses for your circuits. If you don’t have any power there then the converter is bad and needs to be replaced.
Why is my 7 way trailer not sending 12V?
The issue is that your truck is computerized even at the 7-way. It can sense when a trailer is connected based on the voltage draw so it won’t sent a signal for 12V when using some testers, especially LED testers because there isn’t enough of a power draw.
Why is my truck not getting 12V power?
Since you are not getting the 12V power when your truck is running, you most likely don’t have a fuse issue as you stated their isn’t a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the 7-way.
If yours are empty like mine were, go get two relays and plug them in. Then get a 30A Maxi Fuse and plug it into position 16 in the under hood fuse box. 16=Trailer Tow Battery Charge. This should give you power to your orange wire (switched 12v) on your 7 pin trailer harness.
With the shore cord plugged in take a VDC reading at the battery to see if it is charging. It should be about 13.6 VDC or so. Unplug the power source and then take a reading at the outgoing leads from the fuses for your circuits. If you don’t have any power there then the converter is bad and needs to be replaced.
What kind of wire do I need for a trailer battery?
For a depleted battery you will need shore power and a charger like the CTEK # CTEK56353. For your trailer’s hot and ground battery wiring I suggest you use 10-gauge wire such as # 10-1-1 from Deka. Produced to make sure you know what you are getting and you get exactly what you need. To make sure products work and fit the way they are supposed to.
The issue is that your truck is computerized even at the 7-way. It can sense when a trailer is connected based on the voltage draw so it won’t sent a signal for 12V when using some testers, especially LED testers because there isn’t enough of a power draw.
