Where to place the Airxcel 9430 series thermostat?

1. Locate the thermostat on an inside wall about five feet above the floor. Pick a dry area where air circulation is good. 2. Do not install thermostat where there are unusual heating or air conditioner supply register. 1. Place mounting screw template against the wall where thermostat will be mounted. 2.

How to bypass the anti short cycle Airxcel 9430?

To bypass the anti-short cycle, change the mode to OFF. below 50°F can cause damage to your cooling equipment. please remove the plugs and use wire nuts as needed. breaker to the Off position before removing the existing thermostat. This thermostat is a sensitive instrument. For accurate temperature control and 1.

Where can I buy Airxcel wall thermostats in Wichita KS?

– RV PRODUCTS DIVISION 3050 N. St. Francis Street Wichita, KS 67219 316.832.3400 . . . reinventing comfort! AIRXCEL,…

St. Francis Street • Wichita, KS 67219 • 316.832.3400 • WALL THERMOSTATS part Number: Case Color: Description: 6535-3442 Black 2 Stage Heat/Heat Pump, Digital Wall Thermostat

Is the fuse on the Airxcel thermostat replaceable?

The thermostat is intended for use with a 12 VDC control circuit that does not exceed 1 amp. The thermostat is equipped with a replaceable 2 amp fuse located on the base of the thermostat. The fuse is designed to “open” if the circuit is mis-wired or if there is a short in the system. Before replacing the

Why is my Airxcel thermostat not turning on?

Here is my best guess: The Tstat controls a relay on the Furnace’s control board. When the Tstat calls for heat the relay on the Control Board turns on the fan and then after sensing the “Sail Switch” is in the proper position the Control Board opens the Propane Valve and sends power to the Igniter.

Which is Honeywell thermostat did you use?

I replaced our AirXcel thermostat as its variance was all over the map. Replaced it with a Honeywell home thermostat which gave us automatic change-over from Cool to Heat or vice versa and much better accuracy. Good Idea, which Honeywell Tstat did you use?