Where is the temperature sensor located on a hot tub?
On most hot tubs, this sensor is located just inside of the filter housing. The temperature probe should be pushed down securely into the thermowell, and the capillary should not have any kinks.
What does a hot tub temperature sensor do?
Hi limit sensors are the way you hot tub tells the control system that all if ok, if the hi limit sensor detects any issues with the temperature of the water in your hot tub it will send a signal to the control system and will automatically shut off the heating until the fall is corrected.
How does a hot tub temperature sensor work?
Newer hot tubs typically have a temperature sensor that gets inserted into what’s called a thermal well, basically coming into almost direct contact with the water. That sensor works in conjunction with your display panel as both get connected to your control box.
What kind of temperature sensor do I need for my hot tub?
Sundance Spa Hi-Limit sensor with Curled End connectors, used on 680/780/850E series systems. Sundance Spa temperature sensor with boxed end connectors, used on 850/880 series systems. Sundance Spa sensor with curled end connectors, used on 680/780/850E series systems.
How do you remove sensor from Sundance Spas?
To Remove a sensor or switch wire from the sensor harness connecto r (J6), Insert the end of a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine,allowing the wire to be pulled from the harness connector.
How many degrees are in the Sundance Spas temperature sensor?
Fareinheit Celsius OHMSΩ 59.00 15 48840 60.8 16 46680 62.6 17 44610 64.4 18 42630
What kind of sensors are used in a jacuzzi?
Original set of Emerald spa sensors. This 2-in-1 sensor set includes the temperature sensor for the water temperature and the hi limit or over-limit sensor for the heater to detect unsafe operating temperatures and conditions. Comes with plug that… Gatsby spa temperature sensor also used in Jacuzzi and Blue Ridge models.
What does the Sundance spa temp sensor 6600-167 do?
The Jacuzzi Spa Temp Sensor 6600-167 is a service part intended for professional repair and maintenance of both Sundance Spas and Jacuzzi hot tubs. This part does not include O-ring 6540-228 (sold separately). This part fits multiple models and years of Sundance Spas and Jacuzzi.
Are there temperature sensors in the hot tub?
Hot Tub & Spa High Limit & Temperature Sensors. Hot Tub Sensors from Balboa and Gecko. — Hot Tub Warehouse
What to do if your Sundance Spa hot tub is not working?
If condition persists, contact your Sundance Spas dealer or qualified service technician. If the hot tub water is more than -7C cooler than the temperature set point, jets pump #1 and heater will automatically activate to provide freeze protection.
How to replace a temperature sensor without draining the spa?
2. Connect the new sensor and toss it over the top of the spa into the water, 3. Wait for a few minutes, then power the system back on and see if everything works as it should. – If the system works as it should, disconnect the new sensor wires from the plug at the circuit board and exit the wire from the control box. Continue on to Step 4.
