Where is the roll out switch on a Raypak pool heater?
Hi, the rollout switch connects inside the cabinet right behind where the gas pipe comes into the gas valve.
What to do if your Raypak pool heater goes bad?
1. Possible excessive water temperature in the tube bundle. Once heater cools, high limits resets automatically. 2. Check for blockage in tubes. 3. Check for low water flow. 4. Check Unitherm governor- replace if necessary 1. Possible excessive water temperature in the tube bundle. Once heater cools, high limits resets automatically. 2.
When does the fault code appear on a Raypak heater?
Raypak Heater Fault Code Guide 1 Water temperature is below 36F or above 110F 2 If the two thermistors are more than 2 degrees apart, the SNS code will appear. 3 Loose or corroded connection at P1. 4 If the sensor is not mounted all the way into the JACO fitting on the header, it may give a false reading.
What does BD1 mean on a Raypak heater?
The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you. Error codes are both curses and blessings. Although an error message is never really a good thing, at least it’s an indication of what the problem is. Just imagine how much easier it would be to diagnose diseases if humans came with error codes.)
What should the spa temp be on a pool heater?
When it shut down at 90F I disabled the pool actuators and switched the P4 Aqualogic to the pool setting. I previously also set the pool setting to 102F. The heater immediately restarted and the spa temp rose the 102F setting.
Where can I buy Raypak pool heater parts?
Heater kits and accessories fully satisfy Raypak Manufacturing Company’s performance standards and are certified and warranted by Raypak. Parts for all Raypak products parts including Water Heaters, Pool & Spa, Heating boilers are available through independent contractors who install and maintain Raypak products.
Raypak Heater Fault Code Guide 1 Water temperature is below 36F or above 110F 2 If the two thermistors are more than 2 degrees apart, the SNS code will appear. 3 Loose or corroded connection at P1. 4 If the sensor is not mounted all the way into the JACO fitting on the header, it may give a false reading.
What causes a Raypak hot water heater to overheat?
Low gas pressure can cause sooting that would keep the heater from venting properly, and in time, overheat. Removing the pagoda and or the stackless top will reveal any leaves/debris that may have collected on or around the top of the exchanger causing the over temp issue.
How to check the high limit in Raypak?
I would start by removing the Hi Limit 2 from the header (should be yellow wires) and let it hang by the wires, and see if you still get the fault. If you do, remove the other high limit (black wires) and plug it into the yellow wires, and the other hi limit into the black wires (switching them).
