Where is the reset button on a Vita spa?
The reset button is located in the equipment compartment. Plug the spa back into the power source. Check the circulation pump if the spa does not heat while jets and lights are working.
What causes the spa side error code to go away?
Depending on where the temp sensor is mounted; usually in the wall of the spa in a sensor mount, you could have a flow issue. Shut the spa down, remove the filter and make sure all the jets are open. Then power the system back up, if the error code goes away, the problem was either a dirty filter (clean or replace) or too many jets were closed off.
What are the error codes for Master Spa?
Please note that the Balboa Error Codes cover all circuit board manufactured by Balboa including Cal Spa, Marquis Spa, Master Spa and many others. Gecko Error Codes also cover any control box manufactured by Gecko. Overheat. Spa has shut down. One sensor has detected 118º F at heater. Overheat. Spa has shut down. One sensor has detected 110º F.
What to do if your hot tub has an error code?
If however you have the fault then the first thing to do is shut the spa down, do not empty, remove the filter and make sure all the jets are open (as best you can). Then re-start the hot tub, if the error code goes away, the problem was either a dirty filter (clean or replace) or too many jets were closed off.
What should I do if my Spa is not working?
Shut the spa down, remove the filter and make sure all the jets are open. Then power the system back up, if the error code goes away, the problem was either a dirty filter (clean or replace) or too many jets were closed off.
Why does my Vita spa not turn on?
Overheating condition where a water temperature sensor has detected water temperatures of 110°F (43.3°C). Spa functioning is then disabled until temps fall below 108°F (42.2°C).Could indicate a pump operating at low speed for an extended time, constant filtering due to a programming error or a faulty pump. DO NOT GET INTO THE WATER!
How do I Reset my Vita Spa hot tub?
If your Vita Spa controls stop working, the company recommends performing a system reset before troubleshooting or calling for repair. Resetting your hot tub involves pressing a particular combination of buttons on the control panel. Tap the “Prog” button until the time appears on the display. Press and hold down the “Down” arrow button.
Are there error codes for digital hot tubs?
The best thing about digital spas and hot tubs – those with a spa side control panel – is that you are given error codes for most equipment problems. Spa error codes can be somewhat cryptic, but when you have the BIG LIST of CODES, you can immediately define the two or three digit source of trouble.
Which is the correct error code for spa?
(Displays when first powered up after refill). Spa operating in Standard Mode. Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.
