Where is the pilot light for hot water?
It is located on the outside of the water heater where the gas pipe enters the unit and has have a knob on it. The valve regulates gas flow to the pilot burner beneath the hot water tank. Turn the valve knob to the “Off” position.
Can you have hot water without pilot light?
Natural gas water heaters that do not have a continuously burning flame or pilot light are said to be pilotless. This reduces the amount of energy needed by the appliance, conserving fuel and reducing emissions. The technology is limited to on-demand water heaters.
What to do if your water heater pilot light goes out?
Reassemble the water heater and check back later if the pilot light keeps going out and if you have hot water. This quick maintenance fix is manageable by any homeowner however if you don’t feel safe and you still have no hot water, call a service technician to troubleshoot and repair your water heater.
How to relight your gas hot water pilot flame?
If the pilot flame on your gas storage hot water system needs relighting, the instructions below show you how. These instructions will work for most gas storage hot water systems. To remove the access panel on a Rheem water heater, pull the bottom straight up. The whole panel should move up about 5mm.
Why is my gas hot water pilot not working?
In the picture above, a yellow arrow points to the Piezo ignition button (which is not uncommonly broken and not working). Sometimes the reason the igniter doesn’t work is because the ignition lead (indicated by the orange circle) has fallen off or is broken.
How can I see if there is a flame under my water heater?
Depending on your water heater, you can actually see if there is a flame underneath the tank. Turn the pilot light knob onto “pilot”. Press down on the knob and hold down the ignite button for a minute to turn the flame back on.
Where is the pilot light on my hot water heater?
Steps to relight the pilot light. Turn off the gas. Locate the gas shut-off valve on your hot water heater. Find the pilot light access. Typically, this will be under the gas valve. Open the cover to the pilot (if one is present) and look inside the opening with the help of a flashlight to find the burner, along with two gas tubes.
Why is my gas water heater pilot light yellow?
Also, some homeowners reported that while they were cleaning the unit, a small orifice cap found on top of the pilot tube fell out making the pilot light unstable, yellow and very high. If the gas pressure is too low, the flame can become too small. Check with the utility company about this problem.
What to do if you have the wrong pilot light?
If you have the wrong pilot burner replace it with the correct one. Important: Before troubleshooting the pilot light, keep in mind that a pilot flame is always ON and the flame should be blue. If it is yellow, it needs an adjustment. Make sure that the tank is completely filled with water before lighting the pilot light.
Why does my water pilot keep going out?
Therefore, a dirty thermocouple might be the reason why your water pilot keeps going out. A layer of dirt and grime can hinder the electric current from reaching the thermocouple. As a result, the gas supply will be cut off and the pilot light will go out.
