Where is a thermostat sensor located?
The thermostat sensor is located near the evaporator coil that is within the inside of your AC unit. Air moves past the sensor and coil, it takes not of the temperature and will compare it to the desired temperature. The sensor activates the compressor should your home or office need to be cooled.
How do you clean a thermostat sensor?
Thermostats can be cleaned by first removing the cover. Second, take a very soft brush (paintbrush) or compressed air to gently clean between the contact points and/or lever switches.
How many degrees are in the Sundance Spas temperature sensor?
Fareinheit Celsius OHMSΩ 59.00 15 48840 60.8 16 46680 62.6 17 44610 64.4 18 42630
What kind of temperature sensor do I need for my hot tub?
Sundance Spa Hi-Limit sensor with Curled End connectors, used on 680/780/850E series systems. Sundance Spa temperature sensor with boxed end connectors, used on 850/880 series systems. Sundance Spa sensor with curled end connectors, used on 680/780/850E series systems.
How do you remove sensor from Sundance Spas?
To Remove a sensor or switch wire from the sensor harness connecto r (J6), Insert the end of a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine,allowing the wire to be pulled from the harness connector.
Why are temperature sensors important in a spa?
Temperature sensors are a very important part of your spas control system as they monitor the water temperature and tell the control system when & when not to turn the heater on, protecting you and the spa from overheating water conditions.
Fareinheit Celsius OHMSΩ 59.00 15 48840 60.8 16 46680 62.6 17 44610 64.4 18 42630
Can a high limit temperature sensor be repaired?
The high-limit temperature sensor is non-functional. This must be repaired only be a Sundance Spas dealer or qualified service technician. OPEN or SHORTED SENSOR (heater disabled) The main temperature sensor is non-functional. This must be repaired only be a Sundance Spas dealer or qualified service technician.
To Remove a sensor or switch wire from the sensor harness connecto r (J6), Insert the end of a paper clip into the slot corresponding with the wire to be removed. This will depress the pin tine,allowing the wire to be pulled from the harness connector.
Is the heater disabled on a Sundance spa?
OPEN or SHORTED SENSOR (heater disabled) The main temperature sensor is non-functional. This must be repaired only be a Sundance Spas dealer or qualified service technician. CLOSED or SHORTED FLOW SWITCH ON SYSTEM STARTUP (system disabled) Flow switch is non-functional.
