Where can I repair my Spyder control system?
A certified Tiffin repair technician will be able to take it from there. To find a Tiffin-approved service center near you, search your area here.
How does the Spyder control multiplex system work?
Below is when we introduced the Spyder Multiplex System in each model. There are two terminator resistors installed in each network. We solder them right into the circuit board keypads. There is a diagram included in each motorhome’s manual to show you which switch panels contain the terminators.
How does Spyder controls maintain strict quality control?
Spyder Controls’ thorough attention to details in the design, production and testing procedures ensures we provide each OEM customer superior quality products. We maintain strict quality control through meticulous and repeated testing in our production procedures.
What should my multimeter reading be on my Spyder?
If everything is running properly, your multimeter will show 60 OHMS. If there is a bad reading (anything besides 60 OHMS) on your multimeter, you may have a break in your cables that connect into your switch panels.
What to do if spyderx sensor is not detected?
Plugging the sensor directly into the USB ports (virtually all of them including 2.0 and 3.0) using no extenders Finally plugged in the sensor (first time – detected by Windows and reported to be working properly (Device Manager)) Run AutoCal – every time I click on detect sensor (SpyderX) it comes back not detected!
Spyder Controls’ thorough attention to details in the design, production and testing procedures ensures we provide each OEM customer superior quality products. We maintain strict quality control through meticulous and repeated testing in our production procedures.
Below is when we introduced the Spyder Multiplex System in each model. There are two terminator resistors installed in each network. We solder them right into the circuit board keypads. There is a diagram included in each motorhome’s manual to show you which switch panels contain the terminators.
What to do if your Spyder control panel breaks?
If there is a bad reading (anything besides 60 OHMS) on your multimeter, you may have a break in your cables that connect into your switch panels. But not to worry – if there is an issue, you’ve already identified where it’s located. A certified Tiffin repair technician will be able to take it from there.
