Where can I get replacement parts for my Raypak pool?
Parts for all Raypak products parts including Water Heaters, Pool & Spa, Heating boilers are available through independent contractors who install and maintain Raypak products. Find quality products and parts in the new Master Catalog which is a complete reference to Raypak authorized replacement parts.
How to replace hot surface igniter on Jandy lite2 pool heater?
Part#: R0367100*DISCLAIMER*This video involves disconnecting and reconnecting natural gas p… Hot surface igniter repair on the Jandy Laars Lite2 pool heater. Part#: R0367100*DISCLAIMER*This video involves disconnecting and reconnecting natural gas p…
How do you replace a Raypak front door heater?
1. Turn off the power to the heater. 2. Turn off the gas to the heater. 3. Remove front door. 4. Remove the four screws on the side of the heater holding the control panel. See Fig. 1and Fig. 2. 5. Lay control panel forward toward you to access the back of the temperature control board. P/N 241169 Rev.-3 LARGE DOOR SCREW
What to do if your Raypak pool wont ignite?
If it is a stuck orifice, I would replace the pilot assembly. Right when the heater begins its buzz to ignite the pilot, you should hear a click. That would be the pilot valve solenoid. You may have to take the door off to hear.
What should PV-MV / PV check on a Raypak pool?
MV- MV/PV is checking voltage for the main gas valve solenoid after the pilot is lit. You should be checking PV-MV/PV to see if the pilot solenoid of the gas valve is getting 24V. But you also need check LP supply pressure and outlet pressure from the gas valve and possibly the pilot orifice if both inlet and outlet pressure measured good.
What should I check on my Raypak 266A pool?
You should be checking PV-MV/PV to see if the pilot solenoid of the gas valve is getting 24V. But you also need check LP supply pressure and outlet pressure from the gas valve and possibly the pilot orifice if both inlet and outlet pressure measured good. Sometimes the voltage is a plus/minus of what you should have.
Why does my Raypak heater not light the pilot?
I turn it on and hear the ignition trying to light the pilot light but the pilot does not light. Clogged orifice? If so, can these be unclogged with a lighter or do they need to be disassembled?
