Where can I get a Jandy Pro valve actuator manual?

This manual contains information for the proper installation and operation of Jandy®Pro Series Valve Actuators (JVA). Procedures in this manual must be followed exactly. To obtain additional copies of this manual visit For address information, see back cover. 2.2 Description

What kind of valve do I need for a Jandy pool?

Jandy Valve Actuators are designed to meet the needs of today’s more advanced, automatic pool equipment. These fully adjustable actuators offer versatile pool/spa automation with easy setups. All actuators work with the Jandy AquaLink®RS Control Systems and are available in 24 volt units. JVA 2444 Specifications

How to install a JVA on a pool Valve?

Place the actuator onto the valve. 5. Rotate the actuator while keeping the two shafts engaged until the screw holes on the actuator legs align with the empty screw holes (from step 2) in the valve (see Figure 6). 6. Use the four (4) large 2″ Phillips head screws (included with the JVA) to secure the JVA to the valve. 7.

What is the voltage of a JVA 2444 valve?

JVA 2444 Specifications Voltage 24 VAC Amperage 0.75 AMPS Cycles 60 Hz Wire Black Red White 3-conductor Common Switch Leg Switch Leg Figure 2. Standard JVA Mounting A B (Common Port) C A B (Common Port) C Figure 1.

Are there valve actuators for automatic pool systems?

Valve Actuators are designed to meet the needs of today’s more advanced, automatic pool equipment. These fully adjustable actuators offer versatile pool/spa automation with easy setups. All actuators work with AquaLink®RS Control Systems and are available in 24 volt units.

Where is the plumbing position on a JVA?

3.1 Standard JVA Position Standard Plumbingposition is with the middle port (B) as the incoming or common port to the valve (see Figure 1). Standard Mountingposition is with the main body of the actuator over port B (see Figure 2).

What kind of pool Valve does Jandy use?

A distinctive three-way valve, the unsurpassed Jandy Valve helps simplify complex plumbing layouts so you can feel confident that your pool will operate smoothly time and again. The most requested swimming pool valve on the market is the Jandy Diverter Valve. Jandy diverter pool valves divert water and are available with two or three ports.

How to install a Jandy never Lube 3 way valve?

Jandy Pro Series Never Lube® 2”- 2½” Three Way CPVC Valve Installation Instructions Shut Off Stop 2 1/2” Coupler 2 1/2” Pipe 2” Pipe Spli Fit Lock Knob PLUMBING One valve designed for both 2” and 2½” pipe. 2” pipe slip fits into valve ports. 2½” pipe is joined using 2½” pipe coupler, 45° or 90° fitting. See figure below.

What do you need to know about pool check valves?

A pool check valve is a type of pool valve that provides for one-way water flow, or more importantly, to prevent the flow of water in the opposite direction. Some pool check valves also allow you to monitor the flow of water through a clear lid to ensure proper pool check valve operation.

What do you need to know about a valve handle?

VALVE HANDLE USE Lock Knob- Loosen lock knob to turn handle. To secure handle, turn knob down finger tight. See figure below. Off Indicator- OFF area on indicator represents exact position of internal valve diverter seal. Handle Stops- Protruding shut off stops located on valve cover will stop diverter in complete port shut-off position.