Where can I find the Raypak 131 service manual?
TM018 Raypak 131 Type A Pool & Spa Heaters REV: A D.O.I: 8/04/2009 Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”… Page 17 (EIB) to provide additional switching of remote components i.e. pool lighting, garden lighting and/or water fountains. A remote controller is also available as an option.
When to reset a Raypak 131 pool heater?
A manual reset (by pressing the red reset button) is still required should the 45°C inlet over temperature cut out open circuit. Plumbing & Installation Diagram TM018 Raypak 131 Type A Pool & Spa Heaters REV: A D.O.I: 8/04/2009 Service.
When does the fault code appear on a Raypak heater?
Raypak Heater Fault Code Guide 1 Water temperature is below 36F or above 110F 2 If the two thermistors are more than 2 degrees apart, the SNS code will appear. 3 Loose or corroded connection at P1. 4 If the sensor is not mounted all the way into the JACO fitting on the header, it may give a false reading.
What are the installation instructions for a Raypak pool?
AS 5601 and the Installation Instructions provided with each pool or spa heater. Should you require further technical advice on a Raypak Pool or Spa Heater, contact your nearest Rheem Service Department where genuine replacement parts are also available.
TM018 Raypak 131 Type A Pool & Spa Heaters REV: A D.O.I: 8/04/2009 Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”… Page 17 (EIB) to provide additional switching of remote components i.e. pool lighting, garden lighting and/or water fountains. A remote controller is also available as an option.
Is the Raypak 131 type a pool heater uncontrolled?
TM018 Raypak 131 Type A Pool & Spa Heaters REV: A D.O.I: 8/04/2009 Service. All printed copies not bearing this statement in RED are deemed “uncontrolled”… Unless controlled, they can lead to excessive chlorine levels that can damage the pool/spa heater.
Raypak Heater Fault Code Guide 1 Water temperature is below 36F or above 110F 2 If the two thermistors are more than 2 degrees apart, the SNS code will appear. 3 Loose or corroded connection at P1. 4 If the sensor is not mounted all the way into the JACO fitting on the header, it may give a false reading.
AS 5601 and the Installation Instructions provided with each pool or spa heater. Should you require further technical advice on a Raypak Pool or Spa Heater, contact your nearest Rheem Service Department where genuine replacement parts are also available.
