Where can I buy Balboa spa Control Board?
If the spa control system board, heater or panel are currently available on the Balboa Direct website, they should be highlighted as active links that will take you directly to the specific page to purchase them.
Where can I find the Balboa BP troubleshooting manual?
42211 C Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group. Balboa’s BP Troubleshooting & Service Manual SPA CONTROL SYSTEMS PANELS60 Hz BP500 BP2000G1 TP900, TP800, TP600, TP400 THIS MANUAL COVERS THE FOLLOWING:
Where are the sensors on a Balboa hot tub?
Note: The below images refer to a Toronto Spa for the location of the control system. Placement varies from spa to spa, but in any case it will be located along the same side of the hot tub as the main control panel. Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below).
How to check water temp on Balboa hot water heater?
Make sure that the water temperature displayed on the topside panel is at least 1 degree below the heater set temperature and set the control to standard mode. 2. Check voltage across the two connections to the heater. Your meter should read either 120 or 240 volts depending on your installation.
When do I need to replace my Balboa BP heater?
A new Heater may be required when the Spa no longer reaches the set temperature (even if it’s set under Ready Mode) or when a fault within the heater is causing the GFCI to trip. To replace the Balboa BP Heater, follow the steps below. Please note that the tub does not need to be drained to complete this replacement.
Note: The below images refer to a Toronto Spa for the location of the control system. Placement varies from spa to spa, but in any case it will be located along the same side of the hot tub as the main control panel. Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below).
Make sure that the water temperature displayed on the topside panel is at least 1 degree below the heater set temperature and set the control to standard mode. 2. Check voltage across the two connections to the heater. Your meter should read either 120 or 240 volts depending on your installation.
42211 C Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group. Balboa’s BP Troubleshooting & Service Manual SPA CONTROL SYSTEMS PANELS60 Hz BP500 BP2000G1 TP900, TP800, TP600, TP400 THIS MANUAL COVERS THE FOLLOWING:
