Where are the knock outs on a pool heater?
The wires from the remote controller should never be combined with the high voltage wire in the same conduit, and for this reason, pool heaters have two conduit installation holes (knock-outs) located next to each other on the side panel. Once the electrical has been installed, it is time to connect the plumbing for your pool system.
What kind of heater does Hayward pool use?
Hayward’s advanced line of heaters delivers the ultimate in comfort and energy efficiency while maintaining ideal pool & spa water temperature all season long. HOW MUCH WILL YOU SAVE?
How to heat a swimming pool with an air conditioner?
1. Turn off the power to the pool filter. 2. Use a PVC saw to cut out a section of plastic pipe leading from the pool filter. 3. Thread an adapter into a T-fitting, then insert a sensor well into the adapter.
Can a pool heater be installed in a shed?
If the pool heater is to be installed indoors or in an outdoor shed or partial enclosure, be sure to properly vent the pool heater to the outdoors. Although this is completely explained in the owner’s manual, this can be tricky for the layman to do properly.
Do you have to have a vent cap on a pool heater?
Because the vent pipe is exposed to the elements, it also must be topped with an approved vent cap, which keeps wind and air from forcing products of combustion back down into the ventilation system. In reaching this safe venting point, installers are urged by manufacturers to avoid horizontal piping runs if possible.
Windows or doors that can be closed are not suitable as venting. You can theoretically build a shed with no doors or windows providing there is sufficient legal combustion air venting. An attic vent fan or “heater range” is not allowable. As a homeowner and DIY installer you can do what you choose.
How big should the draft hood be on a pool heater?
The diameter of the draft hood is based on the National Fuel Gas Code and may vary from model to model. Connected to the draft hood is the vent pipe, which vents products of combustion to the outside air; it must have a diameter equal to, or greater than, the draft hood.
Where is the best place to put a pool heater?
The heater is best located level with the surface of the pool — or as close to level as possible — because manufacturers pre-set their pressure switches for heater installations that are typically 3 feet above or below the pool’s surface. Consult the manufacturer for specific recommendations for elevated or subsurface installations.
