Where are the hot and cold valves on a bathtub?
Beneath all the fancy trim, bathtub faucets with separate hot and cold valves are nearly identical to those of other washer-type faucets. The main difference is in the length of the stem. Long stems are required to reach from the handles to the valves, which are positioned well within the wall behind the tub.
How do you turn off hot and cold water in bathtub?
In some cases it may be necessary to turn the water off at the house service entrance using an adjustable wrench or water supply shut-off key, also known as a curb key. Turn on the hot and cold water in the tub to release residual pressure in the lines.
How do you replace the handle on a bathtub faucet?
Push the handle over the thread-seal tape and onto the stem. Insert the handle screw through the top of the handle and into the stem. Tighten the screw and replace the handle cap. Turn the water supply back onto the bathtub faucet. Attempt to turn the water off and on.
What to do if your bathtub faucet wont turn?
A cracked handle would need replacing, as it cannot grip the faucet stem. If the ridges inside the handle are worn, the handle cannot connect with the stem and control the faucet. Clean the end of the stem with an old toothbrush to remove any water deposits.
In some cases it may be necessary to turn the water off at the house service entrance using an adjustable wrench or water supply shut-off key, also known as a curb key. Turn on the hot and cold water in the tub to release residual pressure in the lines.
How to replace a hot and cold bathtub knob?
Pry the handle button from the front of a round knob with a small flat-head screwdriver to expose the handle screw. Look around the base of a lever knob for a small, round hole.
Beneath all the fancy trim, bathtub faucets with separate hot and cold valves are nearly identical to those of other washer-type faucets. The main difference is in the length of the stem. Long stems are required to reach from the handles to the valves, which are positioned well within the wall behind the tub.
Turn both screwdriver and hex key counterclockwise. Pull the knob off the bathtub faucet stem. Slide a new knob over the stem. If you are using a universal replacement knob, slide any adapter over the stem before you install the knob. Thread the handle washer over the handle screw if applicable. Insert the screw into the round knob.
