When should I replace my sand filter media?
Sand Filter Backwashing simply cleans the sand of all the dirt, debris, and small particles that have accumulated over the past week. The sand should be replaced about every five to seven years.
How to replace the sand in a Pentair Triton 2?
REPLACE SAND – To replace the sand, place a bag on top of the filter and cut out a large corner at the bottom of the bag nearest the hole in the top of the filter tank. ROTATE BAFFLE BACK – Push the baffle back until it is positioned in the center of the tank opening.
How long has the Triton filter been in use?
(Valve NOT included) The Triton II Filter is the result of over 40 years of product evolution and refinement. It has set the industry standard for effectiveness, efficiency, long runs between service and providing years of dependable, low maintenance operation.
How much sand do you need for a pool sand filter?
This chart shows how much sand you’ll need for your pool’s sand filter model: MAKE MODEL PRODUCT # FILTER AREA SAND REQ. PEA GRAVEL PENTAIR TRITON II TR 40 140236 1.92 125 50 PENTAIR TRITON II TR 50 140249 2.46 175 50 PENTAIR TRITON II TR 60 140264 3.14 250 75 PENTAIR TRITON II TR 100 140210 4.91 450 150 PENTAIR TRI
How big is a Triton 2 side mount filter?
The TR60 has 3.14 Sq Ft of effective filtration area and a flow rate of 63 GPM. Turn over Capacity in Gallons : 8 hour (30,240) , 10 Hour (37,800) , and 12 Hour (45,360). (Valve NOT included) The Triton II Filter is the result of over 40 years of product evolution and refinement.
When to replace laterals in a Triton sand filter?
If you are getting sand in your pool or your filter is not filtering as well as it did, it may be time to remove your filter’s sand and look at your filter’s Laterals to see if they are damaged. This guide shows you where the Laterals in your Pentair Triton 2 Side Valve Sand Filter are, and how to check and replace them.
How to replace the sand in a Pentair Triton 2 side valve?
How To Replace the Sand in a Pentair Triton 2 Side Valve Sand Filter. 1 Step 1. COLLECT MATERIAL – Before you start to change the sand in your filter, be sure to purchase any material or equipment you will need ahead of 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.
How often do you have to replace the sand in a sand filter?
The changes are noted via Youtube annotations. Every 5 – 7 years you will have to replace the sand in your sand filter. The sand actually wears out. The sharp edges of the sand particles become worn and rounded and don’t capture the contaminates as well.
