When should I replace my Hayward salt cell?
Salt Cells last for about 3-5 years depending on a few different factors: The size of your salt cell, the size of your pool, not cleaning your salt cell and over-cleaning your salt cell, all effect the longevity of your cell. No or low chlorine levels often times can indicate a bad or poorly working salt cell.
Is the salt level on the Hayward Aqua plus wrong?
I have a hayward aqua plus controller which is not showing the proper salt levels; however, when I bring a water sample in the pool store – my salt level is correct. The controller is about 2000 PPM off so it is never producing chlorine. I have tried a new salt cell but the same result.
Do you need a salt chlorine generator for Hayward pool?
Just like any other salt chlorine generator, the Aqua Rite may need a quick ‘tune up’ from time to time. Using information provided by Hayward Pool, we have created the following troubleshooting guide to help pool owners understand the diagnostic codes and quickly restore their Hayward Aqua Rite salt chlorination system. Important Tips!
Why is my Hayward swimpure plus control board not working?
At first, the board read r 1.59 with the power light on and the red no flow light on. I waited a couple of hours then pressed and held the small button. All lights came on and the small screen read pcb. The reason this whole thing started was that I shut off the filter during hurricane Irma. When I turned it back on I got a salt reading of 1900.
How to recalibrate your Hayward Aqua Rite system?
How To Recalibrate The Average Salt Level To reset your average salt level, turn the unit to OFF and then back to AUTO. Wait for the relay to click (5 to 10 seconds). After the click, immediately push the diagnostic button 5 times to begin the recalibration stage.
I have a hayward aqua plus controller which is not showing the proper salt levels; however, when I bring a water sample in the pool store – my salt level is correct. The controller is about 2000 PPM off so it is never producing chlorine. I have tried a new salt cell but the same result.
Just like any other salt chlorine generator, the Aqua Rite may need a quick ‘tune up’ from time to time. Using information provided by Hayward Pool, we have created the following troubleshooting guide to help pool owners understand the diagnostic codes and quickly restore their Hayward Aqua Rite salt chlorination system. Important Tips!
How to reset salt level on Hayward Aqua rite?
To reset the average salt level, turn the unit off and then back to Auto. Wait for the relay to click (between 5 – 10 seconds). Now, press the Diagnostics button 5 times to display the Instant Salt level on the LCD screen.
What to do if your salt level is above 3200ppm?
If salt level is above the range, partially drain the pool and/or spa and refill with fresh water to achieve a salt level of 3200ppm, refer to page 9, Step D. If the salt level is not high, verify the correct cell is being used then reset (follow steps for How to Reset Average Salt Levels above)
