When does the inspect cell led go out?
Inspect Cell LED will flash by itself when 500 operational hour countdown timer has expired. Requires manual reset. To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds).
How to reset the inspect cell led Aqua Trol?
To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds). Step A If salt level is within range, go to step B. If salt level is below range, add enough salt to achieve a salt level of 3200ppm. (Refer to Salt Chart, Page 27) Step BInspect and/or Clean Cell
When do Check salt and inspect cell LEDs flash?
Solution: The Check Salt & Inspect Cell LEDs will flash at the same time when the salt level is between 2500-2600 ppm. Chlorine is still being produced when the lights are flashing. When these LEDs are ON, the salt level is 2300 ppm or below. This also means that chlorine production has stopped.
How to calibrate a Hayward Goldline chlorine generator?
1 Adjusting Salinity (Salt) level Before the chlorine generator can be calibrated correctly, the salinity—or salt level in the pool water—will need to be at the correct level. 2 Locating the Calibration Screen Once the salinity is adjusted to optimal level, the calibration process can begin. 3 Setting the Salinity Level
To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds). Step A If salt level is within range, go to step B. If salt level is below range, add enough salt to achieve a salt level of 3200ppm. (Refer to Salt Chart, Page 27) Step BInspect and/or Clean Cell
Inspect Cell LED will flash by itself when 500 operational hour countdown timer has expired. Requires manual reset. To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds).
