When do you need a boom lift outrigger?
Boom lift outriggers are a popular method for stabilizing equipment for all kinds of job environments, including construction sites, maintenance facilities, and much more. Outriggers are especially helpful when using lifts on job sites with rough, uneven terrain.
Do you have to use outriggers on scissor lift?
For added safety, many aerial lifts have interlock devices that keep the boom locked in the stowed position until the outriggers are deployed. If the work platform is low and the scissor lift is on solid ground or a concrete slab, you might not need to use the outriggers.
Where do the outriggers work on a truck?
Only diverter valve is at the rear of the truck. I dont see one up in the bed by the controls. Neither upper or lower control work. Only the outriggers work. The turret lower controls have pressure there when i use the diverter at the rear but wont go past those lower controls.
Why does my outrigger not move the bucket?
Can not get the bucket to move. Fluid is full. Bucket safety seems ok. Tool switch not engaged. Joystick controler looks ok. Cant find the override valve. I understand there is a way to stop the outriggers from getting fluid and divert to the bucket. Never had a bucket i couldn’t figure out.
Can not get the bucket to move. Fluid is full. Bucket safety seems ok. Tool switch not engaged. Joystick controler looks ok. Cant find the override valve. I understand there is a way to stop the outriggers from getting fluid and divert to the bucket. Never had a bucket i couldn’t figure out.
Where is the switch for the outriggers on my truck?
The switch on my truck is located outside the truck, next to the ground controls. Sorry if any of that seems obvious, but sometimes it is the obvious thing that is wrong and overlooked. Good luck with it There is usually a switch on the outriggers telling the system that they are down. If one of them is not working the boom will not move.
Where do you attach the spring gate on a outrigger?
Attach the crimp 12 inches (300 millimeters) to 16 inches (400 millimeters) from the spring gate snap attached to the saddle on the gunnel. The spring gate snap is crimped onto the mono leader of the tag line and attached to the cam cleats saddle.
What’s the best way to rig an outrigger?
Single sheet line, rope guide and cam cleat. Ideal for start-up rigging on multi-pin bases set at 90-degree angles from the vessel. For illustration purposes, Black’s clips are shown but AFTCO gold fingers or roller trollers may also be used. This closeup of the rigging shows the rope end stopper, bead, crimp, light sleeve and snap swivel.
