What to do when spa sensationspa is having trouble shooting?
If an ERR 6 has occurred and the above first two items have been rectified, the first thing to do is re-set the controller as follows: depress the up arrow, down arrow and pump buttons on the touch pad simultaneously for 1-2 seconds. If this does not rectify the fault it will be necessary to bleed the pump.
Why is my spa button not working on my Balboa?
Cause: There is an “Over Heated Heater” (OHH or HH) Condition. One of the Water Temp Sensors has detected 118°F (47.8°C) In the Heater and Spa Functions are Disabled. You Must Press Any Button to Reset when Water is below 108°F (42.2°C).
Is there an error code on my spa?
Spa won’t heat above 88′. Getting an error code with what appears to be ————. It was working fine and heated to 104′ a week ago. … read more
Why is my spa not showing up on my computer?
If display shows only this message (blinking) spa is shut down Multiple causes; open sensors, bad connection to panel, improper voltage, etc. Time out error. Rare system error. Spa unusable.
What do you do when your Spa is in manual mode?
When the spa is running in automatic mode, pressing the pump button will deactivate auto mode and set the pump running in Manual Mode. The auto LED is orange when auto mode is enabled and off when in Manual Mode. When the pump is in standby mode all indicator LED’s are off. Pushing the pump button two times turns the pump on and then off.
Why do I get an error message on my hot tub?
The following is a list of most probable causes of this message. Inspect these first: Check slice or ball valves. Make sure that they are open. Make sure the correct pump is installed. Clean the filter/skimmer if there is any blockage. Check heater element alignment. Check for debris on the heater element.
How does the Aux / Air indicator work on the spa?
The Aux/Air indicator LED will appear on the touchpad whenever the Aux/Air button is pushed and conversly will disapear when the button is pushed again. Note: If the spa does not have a load connected to the controller the LED will still operate as described above.
What to do if your Spa is not overheating?
If your spa is not overheating and you are getting the above error codes then a couple of things need to be investigated. Depending on where the temp sensor is mounted; usually in the wall of the spa in a sensor mount, you could have a flow issue. Shut the spa power off, remove the filter and make sure all the jets are open.
