What to do when power steps dont work?
I pulled the 30amp in-line fuse for the power steps, pulled and reinstalled the connector plug at the power step control module. I then spray all the door orifices with lubricant spray. Now the steps work. Let’s see how long that lasts.
Why is the step motor on my RV not working?
If a positive or negative voltage is present when the door switch is activated, then the step motor is getting power, but not working. The step motor is likely bad and needs to be replaced. WARNING: Be careful where you place your hands and arms when reconnecting plugs on the step.
Why are my power steps stuck in the down position?
Dang! for the last two weeks the steps have been stuck in the down position. Yesterday i decided to go through the motions again and test the connections. I pulled the 30amp in-line fuse for the power steps, pulled and reinstalled the connector plug at the power step control module.
Why are the steps on my amp NOT working?
Now, in Florida, the problem is constant: the steps refuse to come down. I sprayed wd-40 in the contector at the amp research power module and at each hinge point. Dome light still functions and the door ajar light on the instrument panel works fine.
I pulled the 30amp in-line fuse for the power steps, pulled and reinstalled the connector plug at the power step control module. I then spray all the door orifices with lubricant spray. Now the steps work. Let’s see how long that lasts.
Why is my Powertrain Control Module not working?
Different sensors in the engine send the PCM data about what the engine is doing. The PCM then adjusts the fuel mixture based on this data. If the PCM is not working properly, odds are that the fuel mixture will not be right. The vehicle may be receiving too much fuel or too little.
Dang! for the last two weeks the steps have been stuck in the down position. Yesterday i decided to go through the motions again and test the connections. I pulled the 30amp in-line fuse for the power steps, pulled and reinstalled the connector plug at the power step control module.
Now, in Florida, the problem is constant: the steps refuse to come down. I sprayed wd-40 in the contector at the amp research power module and at each hinge point. Dome light still functions and the door ajar light on the instrument panel works fine.
