What to do if your swimpure Control Board is not working?
Plug the cord in where the flow switch cord plugs in and see if the flow light returns to normal. If it does then the switch needs to be replaced. You must log in or register to reply here.
Why is my Hayward swimpure plus control board not working?
At first, the board read r 1.59 with the power light on and the red no flow light on. I waited a couple of hours then pressed and held the small button. All lights came on and the small screen read pcb. The reason this whole thing started was that I shut off the filter during hurricane Irma. When I turned it back on I got a salt reading of 1900.
When did my Aqua rite PCB get damaged?
Probably happened in the spring during one of our thunderstorms. I called technical support at Goldline Controls (now part of Hayward) @ 908-355-7995. The helpful rep walked me through pushing the little test button to the left of the LCD display and I read him the readings it displayed.
What is big black disc on Aqua rite PCB?
It turns out that the big black disc is a varistor. A varistor is normally used as a protection device that, at a certain voltage, changes its resistance to a low value. It essentially “shorts out” voltage spikes. The idea is to protect from things like power surges caused by lightning strikes and the like.
At first, the board read r 1.59 with the power light on and the red no flow light on. I waited a couple of hours then pressed and held the small button. All lights came on and the small screen read pcb. The reason this whole thing started was that I shut off the filter during hurricane Irma. When I turned it back on I got a salt reading of 1900.
Plug the cord in where the flow switch cord plugs in and see if the flow light returns to normal. If it does then the switch needs to be replaced. You must log in or register to reply here.
Probably happened in the spring during one of our thunderstorms. I called technical support at Goldline Controls (now part of Hayward) @ 908-355-7995. The helpful rep walked me through pushing the little test button to the left of the LCD display and I read him the readings it displayed.
Is it safe to replace circuit board in Spa?
****Disclaimer: While replacing the circuit board on your spa yourself may seem like an awesome DIY project, it is highly recommended that you leave the actual installation work to a licensed spa professional. This will ensure proper installation and safety, as it is a tricky and sometimes extremely dangerous procedure.
