What to do if your spa has a low flow heater?
If your spa is equipped with a priming mode, turn the breaker OFF and ON. This may do the trick. If not, you must open the access panel on the spa, and locate the correct pump. Some spas have independant circulating pumps, and some use the jet pump on low speed to circulate and heat the water.
How to troubleshoot a flashing Flo for a spa?
First verify your spa is receiving the specified incoming voltage into the circuit board as well as out of the circuit board to the transformer. Also, check all fuses for continuity. Next, check the service tag on the side of your circulation pump. This will tell you approximately what voltage your circulation pump should be getting.
What to do when your spa panel is not working?
Contact your Dealer or Service Organization to check the Switch Numbers or Setting Values Displayed, and Correct as Necessary to Match the Equipment in the Spa System, or Continue for a Detailed Test Procedure. 1. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode.
When does a spa shut down the heating system?
It can sense when there is a reduction of water flow passing through the heating system. When this reduction of water flow happens, your spa is designed to shut down the heating system, protecting itself from overheating or burning up altogether.
How to fix your ” low flow ” spa problems?
If so, take a look at our helpful video showing you how to fix this issue by simply removing the outlet screen in your tub. This screen tends to get clogged, therefore blocking and preventing the circulation and ozone from getting into the spa. Once screen is removed, clean it out, wait for water to reheat, and place back in tub.
What to do if your spa error code is Flo flow?
Proceed step by step, and you should be able to find the cause of the FL, FLO, FLOW or LF error code. If you need further assistance with spa trouble codes, feel free to give us a call at 800-770-0292.
What to do if your hot tub has an LF error code?
Be sure there is nothing floating in the spa water that could get pulled into the plumbing, i.e. leaves, scumballs, etc. Turn the breaker to the spa OFF, and then cycle it back ON. Keep your filters out of the spa, and determine whether the LF error code has disappeared.
How to turn off a strong spa pump?
Press the JETS1 button to turn on the pump, then let it run for 10 seconds. The pump should be running on low speed. Press the JETS1 buttons again and let the pump run on high speed for 10 seconds. Press the JETS1 button again to turn off the pump. The pump should be left in the off position for 10 to 15 seconds.
