What to do if your pool has a 170 code?
Contact a pool professional. Contact a pool professional. Measured significant cell current when SCRs were turned off. (Generates 170 code – front board service) Contact a pool professional. Contact a pool professional. Contact a pool professional. ORP unit or external controller has shut off chlorine production.
What to do if your Jandy pool is not working?
1. Recalibrate salt reading. 2. Backwash your filter if a DE filter is installed. 3. Partially drain your pool and dilute with fresh water until salinity level returns to 3.0. 1. Typically caused by low AC voltage from back board. Check the transformer and back board. 2. Troubleshoot with Jandy or a licensed professional. 1.
What is code 172 on Jandy aquapure error code?
Salinity sensor sees less than .2 GPL of salt. Either there’s no salt in the pool or sensor is air locked. Flow salinity sensor temperature probe error codes. 1.They all generates code 172- Flow sensor service is required. 2. Perform diagnostic test on board to ensure the board isn’t faulty. If not the board, the tri-sensor is the culprit. 3.
What to do if your service code is wrong on your pool?
Conclusion: While most service codes can be solved by the pool owner, not all are immediately fixable, and if this happens it’s important to contact a local service technician who can identify and correct the error to ensure safety and warranty compliance.
Contact a pool professional. Contact a pool professional. Measured significant cell current when SCRs were turned off. (Generates 170 code – front board service) Contact a pool professional. Contact a pool professional. Contact a pool professional. ORP unit or external controller has shut off chlorine production.
When to test chlorine residual after adding hypochlorite?
At 30 minutes after the addition of sodium hypochlorite there should be no more than 2.0 mg/L of free chlorine residual present (this ensures the water does not have an unpleasant taste or odor). 2.
What is the EPA reference level for chlorine?
EPA has not established a Reference Concentration (RfC) for chlorine. (2) CalEPA has established a chronic reference exposure level of 0.00006 milligrams per cubic meter (mg/m
Why does ORP unit shut off chlorine production?
ORP unit or external controller has shut off chlorine production. Temperature of Pool is < 50ºF (10°C). Chlorine production stopped. In “Boost” mode unit will operate at 100% production for 24 run time hours. Input has exceeded Maximum Range. AquaLink RS is controlling the AquaPure and desired output percentages.
Why is there no chlorine in my chlorinator?
Using salt test strips is recommended, even if your unit displays a digital salt level – it could be wrong. Check the water flow. Dirty pump baskets, clogged impellers or filters can reduce water flow to such a low point, that very little chlorine is produced.
What is the code for a low power supply in a pool?
Contact a pool professional. Front board power supply either too low or too high. (Generates 173 – Low input voltage code if Level 2 code 188 is present) (Generates 170 code if 188 is not present) Contact a pool professional. VAC input voltage is too low.
