What to do if your Jacks wont retract?
Now the jacks should retract with the use of the “STORE” function on the touch panel. IF THE JACKS WILL STILL NOT RETRACT 1. Turn the system off and make sure all solenoid valves are closed. 2. Remove the “U” shaped tube from the shuttle valve (9/16″ wrench) and remove the shuttle valve. A 7/8″ wrench is needed. 3.
Why is my HWH leveling system Jack not retracting?
All the information you need can be found on their web site. My first guess would be the corresponding solenoid is stuck in a slightly open position, or not closing all the way. However, the first thing I would do is with the jacks down is to spray the seal on the jacks with WD-40.
What to do if solenoid jacks do not retract?
IF THE JACKS WILL STILL NOT RETRACT 1. Turn the system off and make sure all solenoid valves are closed. 2. Remove the “U” shaped tube from the shuttle valve (9/16″ wrench) and remove the shuttle valve. A 7/8″ wrench is needed. 3. There should be a small pin protruding from the bottom of the shuttle valve.
Who are the manufacturers of RV leveling jacks?
While most RV leveling jack systems are made by HWH Corporation, there are some other options which might be on your RV. Lippert Systems are a competitor brand in this niche and they tend to operate a little differently.
Now the jacks should retract with the use of the “STORE” function on the touch panel. IF THE JACKS WILL STILL NOT RETRACT 1. Turn the system off and make sure all solenoid valves are closed. 2. Remove the “U” shaped tube from the shuttle valve (9/16″ wrench) and remove the shuttle valve. A 7/8″ wrench is needed. 3.
All the information you need can be found on their web site. My first guess would be the corresponding solenoid is stuck in a slightly open position, or not closing all the way. However, the first thing I would do is with the jacks down is to spray the seal on the jacks with WD-40.
Can a power retract Jack be pried up?
Spring-retract jacks should retract by themselves when the valves are opened. If the springs are missing or the jack does not retract, the jack can usually be pried up using a bar, board or shovel. Power retract jacks will have to be pried up after the valves have been opened. Locate the hydraulic control unit.
IF THE JACKS WILL STILL NOT RETRACT 1. Turn the system off and make sure all solenoid valves are closed. 2. Remove the “U” shaped tube from the shuttle valve (9/16″ wrench) and remove the shuttle valve. A 7/8″ wrench is needed. 3. There should be a small pin protruding from the bottom of the shuttle valve.
What kind of Jack does a Winnebago use?
I used jack stands rated for the vehicle which is a Winnebago Adventurer and I used a tarp to catch the hydraulic fluid that leaked out when I disconnected the strut hydraulic line. I added some more HWH Specialty fluid back in when the job was done.
