What to do if your hot tub has a flow sensor error?
1. I am getting a Flow Sensor Error. Solution 1: If you get a flow sensor error on your hot tub, you will want to turn off your spa. Make sure your spa is full. Then you will want to pull out the filter and put the hose in the hole. Turn the hose on full blast for about 25 seconds.
Why is the flow switch on my spa not working?
If the water level is lower than the jets, the flow switch will not work. The spa’s manual will indicate how many gallons the spa will hold and how high the water level should be to function properly. Clean out the filter. Obstructions in the filter will stop the water flow and cause the flow switch to cut off power.
What causes a hot tub to stop flowing?
The most common causes for this are a dirty or damaged filter, low water levels, air in the pipework or a faulty pump or sensor.. What are hot tub flow switches?
What is the water flow sensor on Coleman inflatable hot tub?
What is the water flow sensor. The water flow sensor is just as it’s name says, it is use to tell a system that water is flowing. Seen to the right is the water flow sensor used in many of the Bestway, Coleman and Lay-Z-Spa branded inflatable hot tub models.
1. I am getting a Flow Sensor Error. Solution 1: If you get a flow sensor error on your hot tub, you will want to turn off your spa. Make sure your spa is full. Then you will want to pull out the filter and put the hose in the hole. Turn the hose on full blast for about 25 seconds.
Is it OK to turn off a flow switch in a hot tub?
Always turn the spa off before working on it. The electrical current in a hot tub or spa can cause injury or electrocution. Troubleshooting a flow switch can keep your hot tub or spa running. Flow switches are used in spas and hot tubs to tell the system to turn on and off.
The most common causes for this are a dirty or damaged filter, low water levels, air in the pipework or a faulty pump or sensor.. What are hot tub flow switches?
How to fix your ” low flow ” spa problems?
If so, take a look at our helpful video showing you how to fix this issue by simply removing the outlet screen in your tub. This screen tends to get clogged, therefore blocking and preventing the circulation and ozone from getting into the spa. Once screen is removed, clean it out, wait for water to reheat, and place back in tub.
