What to do if your hot tub controller is not working?

Resetting the spa by turning off the power, waiting and turning it back on is likely to resolve the issue. If these troubleshooting tips don’t solve your problem, consult the owner’s manual for your controller. You can also contact the manufacturer for technical help.

Why is a hot tub control panel important?

A hot tub control panel acts as a timer, keeps the temperature constant, turns off the spa if you forget to, and helps troubleshoot problems with your spa. This is why it is important to keep the control panel in good working order.

Can a hot tub heater be left unattended?

You can leave Spa unattended as the heater will switch off automatically when it reaches the set temperature. Make sure the spa is connected to an electrical outdoor socket designed specifically to protect it from water. Will the heater cut off at a certain temperature?

Why does my hot tub control panel keep blinking?

If there is any condensation, dry it off. A blinking red light on the control panel may indicate it needs to be reset. For most models, you will need to turn off the power to the spa for a minute or two and then turn it back on again. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.

Which is the Best Spa hot tub control?

JED103, Spa Ozonator Kit Complete 120V Corona Discharge, JED 103 Ozone Generator kit with cord and AMP plug, JED103 Ozonator, Spa Ozone Generator, Ozonator, Hot Tub Ozone, JED 103, JED 103 Ozonator ACC KP-1000 Topside Keypad for Spa Controls 2.5″ x 5.5″ fits SMTD1000 and ePack SMTD1500 fits Acura Spas Controls, KP1000

Where is the control panel on my hot tub?

For a control panel that is built into the hot tub if you have a look inside the service bay of the hot tub you will probably see that it is also connected to the hot tub via a cable which will no doubt be plugged in somewhere. Again check for corrosion.