What to do if your hot springs heater is not working?
• Integrated pressure switch open – check for clogged filters. The integrated pressure switch will reset when the flow of water through the heater has been restored. Contact our customer service team for a service if the heater trips frequently.
How to turn on Jets in hot spring pool?
HOT SPRING ONLY: For 240 v spas, turn on the 20 amp breaker and run jets 10 mins, then turn on the 30 amp breaker and continue to run jets 30 min. For 120 v spas, plug in and immediately turn on jets for 10 minutes.
How to troubleshoot a hot spring pool filter?
A quick test to see if the spa filter is the cause: Turn the power off to the spa at the main breaker then take out the filter with the gray knob (make sure that nothing is floating in the spa that could get sucked into the filter area). Turn the spa back on without the filter to see if it begins operating properly.
Why does my hot spring spa have no power?
Ozone humming is normal. It is the vibration of ozone being sucked through the Mazzi Injector. My spa has no power or is not heating and it is a cold winter day, what do I do? If the spa has no power, or is not heating, place a droplight with a 60 or 75-watt bulb inside the access panel over pump one.
• Integrated pressure switch open – check for clogged filters. The integrated pressure switch will reset when the flow of water through the heater has been restored. Contact our customer service team for a service if the heater trips frequently.
HOT SPRING ONLY: For 240 v spas, turn on the 20 amp breaker and run jets 10 mins, then turn on the 30 amp breaker and continue to run jets 30 min. For 120 v spas, plug in and immediately turn on jets for 10 minutes.
A quick test to see if the spa filter is the cause: Turn the power off to the spa at the main breaker then take out the filter with the gray knob (make sure that nothing is floating in the spa that could get sucked into the filter area). Turn the spa back on without the filter to see if it begins operating properly.
How do you turn off a hot spring heater relay board?
Now turn off the power to your spa. Either unplug it if it’s 120 volt model or turn off the breakers if it’s wired 240 volts. Find where the black and white wire from the heater’s power cord connect onto the front of the heater relay board.
Is there an error code on my hot spring?
So, when you see an error code on your spa’s control panel, you might worry that you’ve lost your chance. But don’t fret! Hot Spring ® spa systems are reliable and will last a long time with regular maintenance, but issues do sometimes arise.
Now turn off the power to your spa. Either unplug it if it’s 120 volt model or turn off the breakers if it’s wired 240 volts. Find where the black and white wire from the heater’s power cord connect onto the front of the heater relay board.
What do I need to test my hot spring heater?
• The green “Ready” light on the control panel should be off . • The temperature on the control panel must be set higher than what the temperature of the spa water is. • Have your voltage meter (aka Multi Meter), and a Phillips Screwdriver and needle nose pliers handy.
