What should the temp of a hot tub be when not in use?
On the other hand, if you are thinking of a shorter time of around three or four days away, set the dial to five degrees cooler to gain any benefit on reducing your electricity bill.
What to do if your hot tub is not in summer logic?
Also check to see that your spa is not in Summer Logic (spa water reaches 2 DEGREES above the set temperature). If your spa is in Summer Logic, cool the water off by opening the cover and or adding some cold water to the spa. If neither of these are the case you could have a bad Flow Switch or a bad connection to the Flow Switch.
What are the error codes for a hot tub?
1) Hot Tub Error Codes (Alphabetical) * * * (3 flashing dots under temp displa Flow/Pressure switch either Open or Clos * * * (as above, & red LED lit up on boa High Limit Fault – – – , – – – ‘Watchdog’ – 48C reached, electronic fau – 01 Hi-Limit fault – 02 Temp sensor fault
Why does my hot tub keep saying HFL?
Interlock failure – possible pump/ozone spike – possibly caused by faulty ozonators, pumps and equipment Persistent low flow. (Displays on 5th occurrence of “HFL” message with 24 hours). Heater is shut down High temperature condition, has reached 110ºF.
What should the temperature be in a hot tub?
Refer to your owner’s manual. CoLd = Temperature in the spa heater housing is below 40° F. Status of the heater element is unknown. The low speed pump or circ pump will operate continuously until the temperature rises above 45° F. OH = Over heat. The spa is at a temperature above 108° .
Interlock failure – possible pump/ozone spike – possibly caused by faulty ozonators, pumps and equipment Persistent low flow. (Displays on 5th occurrence of “HFL” message with 24 hours). Heater is shut down High temperature condition, has reached 110ºF.
What does Th1 / 39 Mean on a hot tub keypad?
th1/39 = On startup indicates temperature probe problem. th2/current temperature = On startup indicates temperature probe problem. OH = Overheating, water over 112° F. System will restart when temp. drops. hot = Overheating, water over 112° F. System will restart when temp. drops. HL = High limit switch tripped.
