What should the salt level be on Aqua logic?
The AQL-PS-4 Aqua Logic is consistently reading about 1000 ppm lower than what the pool stores are showing. If anyone can post the sequence of buttons that when followed resets the salt reading it would be greatly appreciated. Thank you all for your insight and taking the time to post.
When does Aqua logic P4 show low salt?
My experience, 10 years with an Aqua Logic P4, and currently on my 3rd cell, is that I get low salt when the salt is not low for some time before the cell completely dies. So, yeah, probably new cell time for you. You must log in or register to reply here.
How many valve actuators can an aqua logic Aql-P-4 control?
The AQL-P-4 can control up to 4 high voltage (120/240V) pieces of equipment, up to 3 automatic valve actuators, and a conventional and solar heater. Both manual and automatic (programmed) operation are available.
What can Aqua logic be used to control?
The Aqua Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Aqua Logic is easy to use, it is important to completely read through this operating manual before attempting to operate the control. NOTE: This manual assumes that the Aqua Logic has been wired and configured according to the Instal- lation Manual.
The AQL-PS-4 Aqua Logic is consistently reading about 1000 ppm lower than what the pool stores are showing. If anyone can post the sequence of buttons that when followed resets the salt reading it would be greatly appreciated. Thank you all for your insight and taking the time to post.
My experience, 10 years with an Aqua Logic P4, and currently on my 3rd cell, is that I get low salt when the salt is not low for some time before the cell completely dies. So, yeah, probably new cell time for you. You must log in or register to reply here.
Is the salt level on the Hayward Aqua plus wrong?
I have a hayward aqua plus controller which is not showing the proper salt levels; however, when I bring a water sample in the pool store – my salt level is correct. The controller is about 2000 PPM off so it is never producing chlorine. I have tried a new salt cell but the same result.
The AQL-P-4 can control up to 4 high voltage (120/240V) pieces of equipment, up to 3 automatic valve actuators, and a conventional and solar heater. Both manual and automatic (programmed) operation are available.
