What should I test Newmar slideout controller for?
Doing this search revealed a troubleshooting guide for our 2005 Newmar’s slideout control boards. This is what I used for my diagnosis. So, I tested as follows: Test – for the correct incoming voltage for the control board. I had 12.8 Volts DC present – No issue with the circuit that supplies power to the controller.
How to use Newmar slide out kitchen slide?
SLIDE- OUT OUT KITCHEN SLIDE— 9 d 16 PNK 12 REDWHT —S O 6 VIO WHT 2—SWlTC OTO ORG HT 2-SWITC 12 ED EL 6 VIO -1 -SWÍTCH Arms Combinational Slide-Out DOO DOO Voice Intellltec LOCATION STOP ADJUSTMENT AOJUSTMENT DEPLETE/DUMP AIR IN COACH SUSPENSION.
Why is my Newmar slide out not working?
Check – Insure the slide out wall locking arms are in the released position. This was quite a task as one was visible (the forward lock) and I could see that it was retracted and not holding the room in. But the aft or (rearward lock) was not visible because it was hidden by our refrigerator wall.
Where are the magnetic sensors on a Newmar slide?
There are also supposed to be magnetic position sensors located on the room. The slide is supposed to have two pairs of these sensors. Two on the coach body, and two on the slide. When the coach sensor contacts the slide sensor, a signal is sent to the control board telling the motor that the slide is fully closed and to shut off.
Doing this search revealed a troubleshooting guide for our 2005 Newmar’s slideout control boards. This is what I used for my diagnosis. So, I tested as follows: Test – for the correct incoming voltage for the control board. I had 12.8 Volts DC present – No issue with the circuit that supplies power to the controller.
SLIDE- OUT OUT KITCHEN SLIDE— 9 d 16 PNK 12 REDWHT —S O 6 VIO WHT 2—SWlTC OTO ORG HT 2-SWITC 12 ED EL 6 VIO -1 -SWÍTCH Arms Combinational Slide-Out DOO DOO Voice Intellltec LOCATION STOP ADJUSTMENT AOJUSTMENT DEPLETE/DUMP AIR IN COACH SUSPENSION.
Where are the cogs on a Newmar slideout?
There is a cog at each slide support rail. The rails support the weight of the slide and provide a track with holes in it to bring the room in or out in conjunction with the momentary switch, motor, axle, and cogs. Pulling myself back inside, I noticed that the axle had play in it. It rotated a bit not much, perhaps 1/8″-3/16″ of an inch.
Check – Insure the slide out wall locking arms are in the released position. This was quite a task as one was visible (the forward lock) and I could see that it was retracted and not holding the room in. But the aft or (rearward lock) was not visible because it was hidden by our refrigerator wall.
