What should I do if my spa control panel is not working?
The connections should be inspected to ensure they are straight and sitting in place tightly. The breaker can be turned on again allowing the spa control system to reboot. If this does not help and since the sensors are brand new with no signs of defect, the problem could be a faulty circuit board.
How do I unlock the hot tub control panel?
However, there are a few steps that are similar if not the same for every hot tub. So, in order to unlock the control panel, users should find and press the “Time” button located on the hot tub’s operating panel. Then, the “Jets 1” button should be pressed followed by the “Set Down” button.
What to do if your hot tub control panel is dead?
This is why it is important to keep the control panel in good working order. Check out hot tub controls on Amazon. If part of the control panel is dead or the whole panel is frozen, you will want to see if the problem is the circuit board or the control panel.
However, there are a few steps that are similar if not the same for every hot tub. So, in order to unlock the control panel, users should find and press the “Time” button located on the hot tub’s operating panel. Then, the “Jets 1” button should be pressed followed by the “Set Down” button.
How to troubleshoot a spa side control panel?
Spaside Control Panel Buttons Not Working Correctly 1 Check for moisture under glass or on contacts 2 Check cable for any rodent damage, crimping or melting 3 Clean plug-in cable connections at both ends 4 Membrane or touch pad buttons may be faulty 5 Inspect circuit board for damage and correct power output 6 Replace topside control
What to do if your hot tub controller is not working?
Resetting the spa by turning off the power, waiting and turning it back on is likely to resolve the issue. If these troubleshooting tips don’t solve your problem, consult the owner’s manual for your controller. You can also contact the manufacturer for technical help.
Who is required to install a Parker Bath?
The Parker bath must be installed by appropriately trained personnel according to the Assembly and Installation Instructions , requirements in the Assembly and Installation Instructions can only be superseded by local code.
