What should I do if my guitar jacks are not working?
Spray a bit of electronic contact cleaner into each jack (I prefer with lubricant, if possible). Cycle a plug in and out 8–10 times so that the contacts open and close, and then leave the plugs inserted in the jacks so that the contacts can dry properly (anywhere between an hour to overnight should be fine).
What should I do if my amp is not working?
Get the amp down to it’s most basic state. Remove all of the speaker wiring and RCA wiring and leave only the power, ground and remote leads connected. If you still have a problem in this state then either your amp is defective or you may have an installation problem such as the amplifier touching metal.
What should I do if the protect light on my amp turns off?
Unplug the connecting wires to see if the protect light turns off. The protect light on an amp is there to keep the amp safe when something goes wrong. Test it by disconnecting the amp. If you’re working on a car amp, simply remove the red wire on its back end.
Why is my amplifier not working in protection mode?
If the speaker wires cause the problem then they are probably touching metal. Check to make sure that a speaker wire isn’t being pinched somewhere between the amp and the speaker. Also check that the speaker wire or speaker terminals aren’t touching the vehicle metal near the speaker opening.
What happens when you press the button on a leveling jack?
Nothing can create that sinking feeling in your stomach quite like pressing the button to operate your leveling jacks and having nothing happen. That can make for a bad start to a trip or it can provide a terrible ending to an otherwise fun getaway. Whether your jacks are stuck up or down can make a big difference in the criticality of the fix.
How to troubleshoot RV hydraulic leveling jacks?
Walk around the RV and put eyes on each of the jacks to determine if there are any obvious issues preventing you from getting the jacks retracted. Look closely to see if there is any hydraulic fluid leaking anywhere as well.
What kind of fluid do you use for leveling jacks?
Hello Joe, Typically Fleetwood used the Power Gear leveling system which is now owned by Lippert Components Inc (LCI). According to the Power Gear manual, they recommend the following: Type A automatic transmission fluid (ATF, Dexron III, etc.,)will work satisfactorily.
How big are the level UP JACKS on a 5th Wheel?
Level-Up® is an Automatic Leveling system. This system is equipped with 14K Aluminum Front Jacks with 21” of travel and 8K Aluminum Leveling Jacks with 15” of travel. The jacks in the Level-Up® system work in pairs.
