What should I do if my aquabot water pump is not working?
Assuming belts are good and installed correctly and a wheel is not falling out of the sideplate, you need a new motor. ROBOT MOVES, WATER PUMP IS NOT WORKING. 1) Check impeller for debris such as hair, weeds or leaves. 2) Operate the robot without the filter bag, if the pump works ok, get a new bag or clean the one you have.
How do you reset the power supply on an aquabot?
Note: Some models have a Reset (Safety) Switch, which must be pressed each time you press the “ON” button. Switch the Power Supply “Off” and “On” several times, allowing approximately 30 seconds between each“ON” and “OFF”. Remember, if your Aquabot comes equipped with a Reset Switch it must be pressed each time after pressing the “ON” button.
How can I test my aquabot Turbo Plus?
Voltage testing a two wire Aquabot Turbo transformer. The above photo is a 6 wire Transformer for Turbo Plus w/remote voltage test. 4) With the robot submerged, wiggle the cord between the handle and the motor. If the robot momentarily comes to life, replace or repair the cord. Check the cord plug end for broken contacts.
What are the most common problems with aquabot?
MOST COMMON AQUABOT TROUBLESHOOTING PROBLEMS. 1) Power cord has a broken wire between motor and handle clamp. 2) Broken or loose drive belt(s). Worn wheel, stepped rollers and drive gear bushings will cause a loose belt. Always replace bushings and rollers with the belts. 3) Plug end is worn or broken.
What to do if your aquabot pool cleaner is not working?
AQUABOT IS DEAD IN THE WATER. If BOTH pump and motor are not working, (Pool cleaner is not pumping water or moving) then the problem is most likely electrical Troubleshoot the power supply 1) Reset your GFI outlet and test the outlet for power with a multimeter on the Vac 200 setting or plug a small appliance into the outlet.
Why does my aquabot stop running after a short time?
replace the pump. AQUABOT STOPS RUNNING AFTER SHORT TIME It may run for a short period after turning power off and on. The most likely problem is the timer on or in the power supply. To check, when the robot stops, unplug the robot from the transformer and check for voltage at the power transformer outlet. This is easy to do with a multimeter.
How can I troubleshoot my aquabot power transformer?
1) Reset your GFI outlet and test the outlet for power with a multimeter on the Vac 200 setting or plug a small appliance into the outlet. 2) Press the reset (if equipped) on the Power Transformer and check the fuse. Some transformers have a reset switch that must be pushed every time the machine is started.
How often do you need to reset the power supply on an aquabot?
Switch the Power Supply “Off” and “On” several times, allowing approximately 30 seconds between each“ON” and “OFF”. Remember, if your Aquabot comes equipped with a Reset Switch it must be pressed each time after pressing the “ON” button.
