What PSI should my pool pump be at?
The size of your pool, the size of your pump, and the condition of your pool water directly impact pressure readings. Generally speaking, a pressure reading between 10 – 25 psi can be considered normal. Once you have installed a new filter, turn everything on and take a baseline reading.
Why is my Pentair pool pump not working?
After work I filled the pool. When I went back to start the pump, I first turned on the wall switch and noticed that the Power LED Indicator on the Control Panel turned on. I then pressed the Start/Stop Button, but nothing happened. Besides the Power LED Indicator, none of the other Control Panel buttons are responsive.
Is the Pentair Superflo vs pump still working?
We have a Pentair Superflo VS pump that was installed 6 weeks ago and had been working flawlessly since installation. Yesterday, however, we discovered a problem.
Why is the control panel on my Pentair not working?
Besides the Power LED Indicator, none of the other Control Panel buttons are responsive. I reset the circuit breaker last night, but the same happened: Power LED is on, nothing else works. I left the power to the pump on all night hoping that it might resolve itself, but it didn’t.
Why does my Pentair pump go into safe mode?
A drive (ie pump) may enter safe mode for a number of reasons like an electrical surge, running dry, etc. It’s a safety mechanism to protect the motor. Frustratingly, this is not in the manual!! I asked why and they said they’ll likely put it into an updated version.
What should I do if my Pentair pool filter is not working?
You can also order any Pentair pool filter parts Complete the cleaning process by removing all sand or diatomaceous earth from inside. Replace filter media and let the filter cycle a few times. Take care not to stuff filter media inside. Ideally, the quantity should be sufficient to keep the pressure correct.
How can I relieve pressure on my pool pump?
Relieve any existing pressure by turning the air relief valve counter clockwise on your pool filter until the pressure reads zero on the pool filter gauge. Remove the pump lid and clean any debris from the pump basket, then fill it with water using a garden hose.
What should I do if my pool pump is not primed?
If water is not flowing freely in the strainer box, return to step one and repeat. Switch the diverter valve back to half way between the skimmer and main drain. If the pump is still not primed, check the impeller for debris and filter pressure for anything 10psi above the clean reading for your pool filter.
Why does my pool pump have a low PSI?
SUCTION LEAK AT PUMP (Low PSI) – The pump lid o-ring, pump intake fitting, and drain plugs are common areas to draw in air. A suction leak in the suction side of the pump can cause a number of problems. If it’s large enough, too much air will be sucked into the system, and the pump will lose prime.
