What kind of water does a vacuflush toilet use?
Vacuum Toilet: The VacuFlush toilet operates in a way different from other marine toilets. VacuFlush systems use a small amount of water (a little more than a pint or .5 liter) per flush in addition to a simple vacuum. The toilet is connected to a pressurized freshwater system. Fresh water is the key to an odor-free bathroom compartment.
What to do if your vacuflush pump is not running?
a.There is a blockage in the system. b.Pump will not run. c.Duckbill valves in vacuum pump are inverted due to blocked discharge line or an attempt to pump out against closed seacock. a.Open flush ball and check the 1-inch (25mm) orifice at the bottom of the base for blockage and dislodge it.
When to use a vacuflush system on a boat?
The VacuFlush system is a holding tank or Type III system as defined by the U.S. Coast Guard. Type III systems are designed to permit operation of the toilet without the direct discharge of untreated waste after every flush. This means onboard toilet facilities can be used when the boat is near swimmers, beaches or shellfish beds.
Why is the flush valve on my toilet not working?
The other cause of running toilet could be that the flush lever is not tightly secured to the wall of the tank. If this is the case, you should try to reach into the tank and tighten the lock nut. Ideally, you should tighten it using your hand to prevent the possibility of cracking your porcelain.
Where is the vacuum switch on a vacuflush toilet?
Vacuum Tank: The vacuum tank stores vacuum energy. System vacuum level is monitored by a vacuum switch located on the vacuum tank. When this switch senses a drop in vacuum in the system, it automatically signals the pump to energize and bring the vacuum to operating level. This process is normally completed in less than one min- ute.
What kind of toilet system does Dometic vacuflush use?
Dometic’s VacuFlush™ marine toilets are high-quality, powerful toilet systems that are only sold exclusively through distributors and dealers. VacuFlush™ toilets have a sophisticated waste disposal system that use stored vacuum vessels and diaphragm pumps to send waste to a holding tank.
What to do if your vacuflush toilet is leaking?
If your Dometic VacuFlush™ toilet is leaking from the base, the floor flange seal most likely needs replacement. If the leak is coming from behind the toilet unit, check the ½” sealing grommet or vacuum breaker. If the leak starts from under the foot pedal, check the ½” water line connection or water valve.
How does overboard discharge work on a vacuflush toilet?
overboard discharge capability must remain secured while within the three-mile limit. The overboard discharge pump is activated by a keyed switch located in the toilet compartment. This key should be removed at all times except when discharge pump is operating. Sewage from any source should not be discharged directly into our waters.
