What kind of pump do I need to replace a 25 HP compressor?
When you are replaceing a large 25 hp compressor pump, you want one that operates under 800 RPM. Our industrial pump comes complete with flywheel, inlet filter silencers and head unloaders. These cast iron pumps are perfect when replacing large Quincy, Ingersoll-Rand, Saylor Beall and Champion Compressor Pumps.
What kind of centrifugal pump do I Need?
Vertical turbine and double suction pumps can handle the most demanding condensate or circulating water needs. Sumps can be cleared with Goulds Pumps’ line of vertical or submersible sump pumps. Heavy duty slurry pumps like the XHD, SRL and 5500 are specially designed for flue gas scrubbers and ash handling services.
Where can I find the Goulds Pump Selection Guide?
Goulds Pumps presents this Pump Selection Guide to assist users in making an easy initial selection of the best pump for a particular service. To do this, simply refer to the selection chart on page 3 where the full line of Goulds Pumps is listed by pump type.
How big of a water pump do I Need?
Self-priming pump up to 8 metres; Install a foot valve or check valve on the suction line; The inside diameter of the pipe must be at least equal to the diameter of the pump ports; To avoid motor to overheating, we recommend not to exceed the limit of 20 startings/hour; Watering of small vegetable plots and gardens.
How big is an end suction 2000 pump?
End suction A-C Series 2000 pumps are available in 1.5” through 8” sizes. Motor sizes through 200 HP, flows to 3100 GPM and heads to 360 ft. All are bronze-fitted construction with working pressure that varies by size from 175-215 psi with 125 psi. There are two configurations, frame mounted and closed coupling.
Vertical turbine and double suction pumps can handle the most demanding condensate or circulating water needs. Sumps can be cleared with Goulds Pumps’ line of vertical or submersible sump pumps. Heavy duty slurry pumps like the XHD, SRL and 5500 are specially designed for flue gas scrubbers and ash handling services.
What kind of coupling does a NEMA pump use?
The frame mounted configuration comes with an ANSI-OSHA-compliant coupling. The coupled configuration is designed for use with NEMA standard close coupled pump motors. Rear pull-out, center line discharge and hydraulic balance – three highly desirable design features are combined to provide reliable performance at low operating costs.
What kind of spa pump do I Need?
OEM Part Numbers DJAYEA-0103 and Replacement spa pump for Sta-Rite® or Dura-Jet brand. This is a dual speed pump with ratings: 1.5HP, 110V, 48-Frame, 60Hz, 2.0 inch intake and discharge.
