What kind of power does a lite2 pool heater use?

The Lite2 LJ heater gets electrical power from an external 115VAC or 230VAC source and provides a dual electronic thermostat control system for pool/ spa combinations or preheat convenience. The Lite2 LJ heater is specifically designed for heating fresh water swimming pools and spas.

What is the installation and operation manual for a lite2 pool?

This manual provides installation and operation instructions for the Lite2 Model LJ pool and spa heaters. Read these installation and operation instruc- tions completely before proceeding with the installa- tion. Consult the Jandy factory, or local factory representative, with any questions regarding this equipment.

Is the Laars Lite 2 pool heater up to date?

It can take a long time to get an up-to-date response or contact with relevant users. laars lite 2 pool heater.

Can a lite2 be used in a salt water pool?

The Lite2 LJ heater is specifically designed for heating fresh water swimming pools and spas. Do not use it as a general service water heater. There is a specially designed model of Lite2 for heating salt water pools. Consult your dealer for the appropriate Jandy products for these applications. 1.2 Consumer Information and Safety

What happens if a lite2 pool is improper installed?

Improper installation and/or operation can create carbon monoxide gas and flue gases which can cause serious injury, property damage, or death.

How tall is a lite 2 pool tube?

LITE 2, NATURAL, 125, LD, 125, NATURAL. LD, 125, NATURAL, FE.HDR./CU.TUBES, ALTITUDE: N= 3K-6K FT.

What do I need to know about lite2 pool and spa?

• Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a nearby phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

What kind of gas does a LJ pool heater use?

Check the rating plate on the inner panel of the LJ heater to be sure that the heater is designed to use the type of gas being supplied to you by your gas company.

What kind of heater does Jandy Laars lite2 use?

Jandy Laars Lite2 Pool Heater Has been replaced with: The New JandyLegacy Heater Ceramic fiber combustion chamber for lightweight, compact design

How to troubleshoot Lite 2 LJ pool equipment?

Replace Ignitor. 1) Check incoming power. (A & B) 2) Turn off incoming power. Check positioning of Conversion Block. 3) Replace Transformer. 1) Check for short circuits. 2) Replace fuse. STEP 4 – Check Fusible Link Check wires for lose connections. Replace Ignition board. 24 VAC on white wire at Fusible Link? (4b)