What kind of pool heater does Raypak make?
Address power, filter and burner issues to keep your pool warm. Although Raypak produces copper-finned boilers and heaters, its lineup of pool and spa products extends to both electric and gas-fired pool heaters as well as digital heaters.
What to do if your Raypak heater is not working?
If we don’t have a solution or do not address your particular issue, it’s always best to contact Raypak directly. The majority of Raypak heaters will have a digital readout. The digital readout helps pool owners read error codes on the actual heater.
What should the pH level be in a Raypak pool?
If you experience these issues, test and adjust your water’s pH balance as necessary. For a fiberglass pool with a water temperature of 68 to 88 degrees Fahrenheit, Raypak recommends a pH level of 7.3 to 7.4, total alkalinity of 120 to 150 parts per million, and calcium hardness of 200 to 300 PPM.
Where do I find the fault code on my Raypak pool?
They are also equipped with onboard diagnostic controls. If there is a safety fault, a fault code will be displayed along with a service indication. (see pic on right) The word “SERVICE” will flash on and off if the PC board detects a known issue. The fault code is displayed in 3 big letters in the lower left of the display.
Why is my Raypak pool light not working?
Clogged orifice yes can be cleaned but if it is dirty or otherwise clogged, the pilot assembly may also be corroded to the point you may break it taking it apart. New assembly is < $100. Stuck or failed PV solenoid (gas valve) or could also be a bad or chewed wire to the gas valve.
What should I do if I find a fault in my Raypak heater?
Power found at either PV or MV at the incorrect time. 1. Turn power OFF and disconnect Ignition Wire and Gas Valve wires from board. 2. Power ON and watch for spark at module. 3. If no spark, turn power OFF, and replace board. 4. If spark is observed, turn off power and reconnect wires. The unit should fire.
What should the spark be on a Raypak pool?
Note: you should get ~28-32V between the PV and the MV/PV connections on the gas valve during pilot IGN. No spark AT THE point of ign.
Why do you need a Raypak pool heater?
Your Raypak pool heater keeps your pool comfortable throughout the seasons. So naturally, it gets a lot of use during that time. While pool heat pumps are built to provide countless hours of heat, they still need maintenance to stay at peak performance.
