What kind of blower does a Pentair mastertemp pool use?
This combustion air blower kit is designed to use with Pentair MasterTemp pool and spa natural gas heater model 400NA and also compatible with Pentair Sta-Rite Max-E-Therm pool and spa natural gas heater model 400NA. It includes single volt blower adapter. Measures 12-inch length by 12-inch width by 12-inch height.
How many pins are on a Pentair mastertemp heater?
This 6 pin board replaces the now obsolete 42001-0096S which was a 9 pin board. To install, with the pins on the right side when mounted, attach the ribbon cable starting from the bottom up, leaving the top 3 un-connected… For Heaters Manufactured after 1/12/09 (New Tub Design).
What causes a Pentair mastertemp heater to soot?
Sooted exchanger (external) due to improper gas pressure or lack of proper venting. either supply of fresh air or exhaust, or both. Heater is being starved of air and the resulting air/fuel mix is too rich (fat). Calcified exchanger (internal) due to improper water chemistry.
When do you turn off the filter pump on a Pentair mastertemp?
A time clock controlling the filter pump should have a low-voltage Fireman’s Switch that switches off the heater at least 15 minutes before shutting off the pump. The “Fireman’s Switch” is a poor name for the 2 wire 24 volt AC remote control system of the heater.
This combustion air blower kit is designed to use with Pentair MasterTemp pool and spa natural gas heater model 400NA and also compatible with Pentair Sta-Rite Max-E-Therm pool and spa natural gas heater model 400NA. It includes single volt blower adapter. Measures 12-inch length by 12-inch width by 12-inch height.
This 6 pin board replaces the now obsolete 42001-0096S which was a 9 pin board. To install, with the pins on the right side when mounted, attach the ribbon cable starting from the bottom up, leaving the top 3 un-connected… For Heaters Manufactured after 1/12/09 (New Tub Design).
A time clock controlling the filter pump should have a low-voltage Fireman’s Switch that switches off the heater at least 15 minutes before shutting off the pump. The “Fireman’s Switch” is a poor name for the 2 wire 24 volt AC remote control system of the heater.
Sooted exchanger (external) due to improper gas pressure or lack of proper venting. either supply of fresh air or exhaust, or both. Heater is being starved of air and the resulting air/fuel mix is too rich (fat). Calcified exchanger (internal) due to improper water chemistry.
