What is the wiring diagram for a Pentair pump?
On a 230v motor install my wiring diagram shows Line 1 as the top post and Line 2 as the bottom post. What color wires are typically associated with which or is there a way to tell what wire should be my line 1 vs line 2? This is a pentair whisperflo. Pentair pump wiring Line 1 Line 2?
What are the hot wires on a 230 pump?
On a 230 line typically you will have two current carrying wires and a ground. The “hot” wires are normally black or red. Like MrClean said, doesn’t matter which hot wire goes to line 1 or line 2. The ground wire should be green and connect to the ground screw.
How to connect single phase motor wiring diagram?
How To Connect Single Phase – Single Phase Motor Wiring Diagram With Capacitor Wiring Diagram consists of many in depth illustrations that show the link of varied things. It includes instructions and diagrams for various types of wiring methods and other items like lights, home windows, etc.
What causes a PTT motor to run in the opposite direction?
The wires being reversed via the relay system causes the motor to run in the opposite direction. The two different type electric motors cannot be interchanged “UNLESS” their associated wiring system (relay/solenoid setup) is interchanged with them. This PTT electric motor existed between 1976 thru 1981.
What is part number for PTT electric motor?
This PTT electric motor existed between 1976 thru 1981. The original OMC part number is 387277 and supersedes up thru the numbers of 582048, 582155, and finally to its present part number of 584107. It appears to be unavailable at Bombardier but it might be available at Sierra under Sierra’s part number of 18-6761.
How does a 2 wire motor system work?
The 2 wire (One “Green” wire, One “Blue” wire) unit incorporates a complex relay setup for both the up and down mode. Via the relay system, the battery negative (-) connects to one of the motor wires, the battery positive (+) connects to the other motor’s remaining wire causing the motor to run in one direction.
What to do if your submersible pump wont turn?
This wiring harness has a plug-in connector right on the motor and can be unplugged after removing the protective metal channel. If that is not the problem, unbolt the pump from the motor, and see if the motor shaft will turn by hand. If it is seized, you must replace the motor.
