What is the white stuff floating in my hot tub?
There are two primary causes of the formation of white flakes in your hot tub: calcium scale deposits and biofilm. As calcium accumulates in the water over time, white flakes will start to form. Biofilm is made up of natural materials shed by those using the hot tub, which is an overgrowth of white water mold.
What to do if your inground Spa is not working?
Blower not plugged in: Plug in the blower. Dirty filter: Clean or replace filter. Jets not properly adjusted: Adjust jets properly – or contact your local dealer. Diverter valve not properly adjusted: Adjust diverter valve properly – or contact your local dealer. Light bulb defective: Replace bulb – or contact your local dealer.
What to do if you have too many people in your spa?
Too many people in spa: Adjust spa water level. Drain valve left open: Shut off drain valve. Couplings or unions loose: Tighten or contact your local dealer. Incorrect water chemistry: Contact your local dealer. Pump seal leaking: Contact your local dealer. Plumbing / connections leaking: Contact your local dealer.
What to do if water is leaking from Spa side control?
Water leaking from spa side control: Contact your local dealer. Water in air blower plumbing: Contact your local dealer. Temperature not set correctly: Adjust setting. Overheat protection switch tripped: Allow unit to cool down and restart by pushing any key. System in wrong mode, check if air blower circuit is on: Refer Heater Operation Section.
Blower not plugged in: Plug in the blower. Dirty filter: Clean or replace filter. Jets not properly adjusted: Adjust jets properly – or contact your local dealer. Diverter valve not properly adjusted: Adjust diverter valve properly – or contact your local dealer. Light bulb defective: Replace bulb – or contact your local dealer.
Do you use the same troubleshooting techniques at the spa?
DISCLAIMER: We at the Spa Care Center use the same troubleshooting techniques that have been provided to you and are fully confident that they work. But, when dealing with water and electricity, it always provides a danger that must be respected.
What to do if your hot tub pump is not working?
Because of the high cost of having a spa pump repaired by a technician, replacing it with a new Master Spas hot tub pump from Master Spa Parts will likely be your most economical option. Plus, Master Spa Parts typically ships same day if order is placed before 3pm CST, so you can have your hot tub up and running again in no time.
Why is the water not hot in my spa?
GFCI trips when powering up the system or when calling for heat. Spa won’t heat. The water gets too hot. Water leaks from around the shaft of the pump motor. I can’t seem to find the leak in my spa.
