What is the thermal cut off fuse on a Dometic water heater?
Dometic (Atwood) 93866 Water Heater Thermal Energy Cut Off (ECO) The Thermal Cut-Off is a one shot heat sensing fuse that’s normally closed and sends power to the thermostat.
Where to find the thermal fuse in Dometic dm2652?
Ceeminor, the thermal fuse I’m familiar with looks like a resistor, connected via spade terminals, with a clear plastic tube to protect from short circuits. This is represented in your schematics by item “Y”. Item “F”, I have no experience with. Item Y should be found close to the firebox. Thanks for the info!
Do you need a slow blow fuse for a Dometic fridge?
In it, you should be able to find the appropriate fuse to use. There exist a very wide range of fuses in terms of speed so it would be risky to use a slow blow fuse where it isn’t required. It also sounds like your heater is drawing more than the normal current as it should not be that sensitive.
What are the different wiring schemes for Dometic?
The following Dometic wiring schemes are provided so that the installer can easily identify the factory wiring scheme. Each wiring scheme is numbered for ease of communication if telephone or e-mail installation assistance is needed.
Dometic (Atwood) 93866 Water Heater Thermal Energy Cut Off (ECO) The Thermal Cut-Off is a one shot heat sensing fuse that’s normally closed and sends power to the thermostat.
Ceeminor, the thermal fuse I’m familiar with looks like a resistor, connected via spade terminals, with a clear plastic tube to protect from short circuits. This is represented in your schematics by item “Y”. Item “F”, I have no experience with. Item Y should be found close to the firebox. Thanks for the info!
When to replace a Dometic water heater control board?
If you are having difficulties the ignition on your water heater, the board could be faulty, or your spark probe could be faulty. Some control boards we made with a 6 position edge connector, if this is the case you will need to purchase the Dometic 92075 Adapter with this board in order to replace your current board.
Do you need a Dometic water heater adapter?
Some control boards we made with a 6 position edge connector, if this is the case you will need to purchase the Dometic 92075 Adapter with this board in order to replace your current board. Qick service and delivery. Installed in 5 minutes and heater back on and working. I did not need the adapter.
