What is the temperature of the spa skirt?
The spa skirt is the space that contains insulation between the outer frame of the spa and the spa itself. The temperature inside the spa skirt is high when the display reads SP-OT. The overall water temperature is over 112 degrees when SP-OH is on the display.
When to replace a gecko spa pack control?
You may need to replace the pack if the display continues to show the wrong water temperature. Measure the voltage of the first wire line and the grounding nut of the terminal block.
How do you turn off a SSPA pump?
Press the Pump 1 key to turn pump 1 on at low speed. A second press will turn the pump to high speed. A third press will turn the pump off. A built-in timer will shut the pump off after 20 minutes unless it has been manually deactivated. The “Pump 1” marker is displayed when pump 1 is running at high speed.
Why are there flashing lights on my spa pack?
Sometimes the spa pack controls will display error codes or flashing lights. When this happens, the owner needs to do a bit of troubleshooting to fix the problem. Loosen the two screws that hold the cover onto the control pack. Lift the cover off to reveal the LED board. Check the LED board to see if there are three flashing dots on it.
The spa skirt is the space that contains insulation between the outer frame of the spa and the spa itself. The temperature inside the spa skirt is high when the display reads SP-OT. The overall water temperature is over 112 degrees when SP-OH is on the display.
What is the installation manual for a Balboa spa?
End User Warning This Installation Manual is provided solely to aid qualified spa service technicians in installing spas with control systems manufactured by Balboa Water Group. Balboa controls have absolutely no end user serviceable parts.
You may need to replace the pack if the display continues to show the wrong water temperature. Measure the voltage of the first wire line and the grounding nut of the terminal block.
Press the Pump 1 key to turn pump 1 on at low speed. A second press will turn the pump to high speed. A third press will turn the pump off. A built-in timer will shut the pump off after 20 minutes unless it has been manually deactivated. The “Pump 1” marker is displayed when pump 1 is running at high speed.
