What is the installation and operation manual for a lite2 pool?
This manual provides installation and operation instructions for the Lite2 Model LJ pool and spa heaters. Read these installation and operation instruc- tions completely before proceeding with the installa- tion. Consult the Jandy factory, or local factory representative, with any questions regarding this equipment.
How to troubleshoot Lite 2 LJ with blue wire?
For Ignitor Test,remove common probe from blue(2) wire. For Gas Valve test reinsert the common probe in with the blue(2) wire. 1) Check incoming power. (A & B) 2) Turn off incoming power. Check positioning of Conversion Block. 3) Replace Transformer. LITE 2 LJ TROUBLESHOOTING 24 VAC between Blue 1 & Blue 2 wires? YES
What kind of power does a lite2 pool heater use?
The Lite2 LJ heater gets electrical power from an external 115VAC or 230VAC source and provides a dual electronic thermostat control system for pool/ spa combinations or preheat convenience. The Lite2 LJ heater is specifically designed for heating fresh water swimming pools and spas.
What should resistance of Lite 2 LJ ignitor be?
Ignitor must be disconnected from the Ignition Control and should be cool to the touch. Depending on the temperature of the ignitor, the resistance between the two leads of a good ignitor will be 25 to 300 Ohms, typically 60 to 80 Ohms. Temperature Rise Test Chart Thermistor Test Remove thermistor leads from ignition board.
This manual provides installation and operation instructions for the Lite2 Model LJ pool and spa heaters. Read these installation and operation instruc- tions completely before proceeding with the installa- tion. Consult the Jandy factory, or local factory representative, with any questions regarding this equipment.
For Ignitor Test,remove common probe from blue(2) wire. For Gas Valve test reinsert the common probe in with the blue(2) wire. 1) Check incoming power. (A & B) 2) Turn off incoming power. Check positioning of Conversion Block. 3) Replace Transformer. LITE 2 LJ TROUBLESHOOTING 24 VAC between Blue 1 & Blue 2 wires? YES
The Lite2 LJ heater gets electrical power from an external 115VAC or 230VAC source and provides a dual electronic thermostat control system for pool/ spa combinations or preheat convenience. The Lite2 LJ heater is specifically designed for heating fresh water swimming pools and spas.
What should resistance of Lite 2 LJ be?
Depending on the temperature of the ignitor, the resistance between the two leads of a good ignitor will be 25 to 300 Ohms, typically 60 to 80 Ohms. Temperature Rise Test Chart Thermistor Test Remove thermistor leads from ignition board. Set meter to test resis- tance above 20 K Ohms.
Can a lite2 be used in a salt water pool?
The Lite2 LJ heater is specifically designed for heating fresh water swimming pools and spas. Do not use it as a general service water heater. There is a specially designed model of Lite2 for heating salt water pools. Consult your dealer for the appropriate Jandy products for these applications. 1.2 Consumer Information and Safety
How tall is a lite 2 pool tube?
LITE 2, NATURAL, 125, LD, 125, NATURAL. LD, 125, NATURAL, FE.HDR./CU.TUBES, ALTITUDE: N= 3K-6K FT.
