What is the first step when flaring a copper tube?
Flaring Steps
- Step 1: Cut your copper or aluminum using a tube cutter to ensure a clean cut – hacksaws and other cutting tools can make for an uneven cut or burrs, which will compromise the flare.
- Step 2: Use a deburring tool or abrasive cloth to remove any burrs and debris in and around the pipe end.
How to make a flare for copper tube?
Clean the end, then apply Flux. Flux is used to minimize oxidation while the joint is being heated Describe the procedures for making a flare for joining copper tube Slip flare nut over the end, clamp the tube in the flaring, yoke over the flaring block, turn the valve screw down the firmly and inspect flare.
What are the flared joints on a copper tube?
Flared Joints. This lowers the flaring cone and forces the lip of the tube against the base of the flaring bar to create an angled flare that will mate securely with a corresponding flare-type fitting. Care should be taken not to over-tighten the cone and cause cracking or deformation of the tube and/or the tool.
How is the flared end of a copper pipe secured?
During assembly, the flared end of the copper pipe is secured to the tapered fitting by the flare nut. It allows for leak-tight and pressure resistant seal. The two parts of flare fitting, the flare nut and the actual flare fitting, should fit easily together. If extreme force must be used to tighten them, they are probably misaligned.
How to make a soldered copper tubing fitting?
Describe the steps for making a good soldered copper tubing/fitting joint. Clean the end, then apply Flux. Flux is used to minimize oxidation while the joint is being heated Describe the procedures for making a flare for joining copper tube
What’s the proper way to flare copper tubing?
A flare nut must go behind the copper tubing prior to flaring. 2. The flared end of the copper tubing is facing evenly against the tapered end of the flare fitting. 3. Both ends must make contact tightly, and perfectly evenly. 4. Slide the flare nut and tighten it to the flare fitting by hand.
What kind of tool do you use to flaring copper?
Measure the copper tubing and cut to the desired length with a tubing cutter . Clean the end of the tubing of burrs with a deburring tool, pipe reamer or sharp knife. When flaring, begin by choosing the tool accessories that match the diameter of the tube to be flared.
During assembly, the flared end of the copper pipe is secured to the tapered fitting by the flare nut. It allows for leak-tight and pressure resistant seal. The two parts of flare fitting, the flare nut and the actual flare fitting, should fit easily together. If extreme force must be used to tighten them, they are probably misaligned.
What’s the best way to join copper tubing?
No-flame Joints. Flameless mechanical joining methods have been used for decades for underground tubing, for joints where the use of heat is impractical and for joints that may have to be disconnected from time to time. Traditional methods include Flared Joints and Roll Groove coupling systems.
