What is the Atwood switch in my RV?
The Atwood 91959 is a screw-on power switch for your Atwood electronic ignition water heater. Mountable on the wall with two (2) screws.
What is the red switch in my camper?
The red light means the hot water heater is not lite. Give it time & hit the switch again & it should lite takes some time for propane to get through the lines.
Is the Atwood RV water heater gas or electric?
The Atwood water heater part # AT94022 is a great option for you as it has an electric element that helps heat the water as well as a gas heating element. The electric element allows the water to heat up a bit quicker so it is a nice option that allows this to produce up to 20 gallons of hot water per hour.
How big is a 10 gallon Atwood water heater?
Ten gallon capacity. 10,000 BTU. Atwood water heaters are designed so that more than 90% of the heat produced by the pilot light is utilized to maintain water temperature eliminating much energy waste. Atwood’s heat transfer system with patented U-tube design delivers more hot water.
Where is the heat exchanger on an Atwood RV?
It has an engine heat exchanger which actually heats view full answer… The heating element on your Atwood model GC10A-4E water heater (our part # AT94022) should be on the backside of the unit, towards the bottom of the tank.
Where is the heating element on an Atwood water heater?
The heating element on your Atwood model GC10A-4E water heater (our part # AT94022) should be on the backside of the unit, towards the bottom of the tank. It will actually be behind the gas line assembly, which will need to be loosened and moved out of the way to gain access to the existing element so it can be removed or replaced.
The Atwood water heater part # AT94022 is a great option for you as it has an electric element that helps heat the water as well as a gas heating element. The electric element allows the water to heat up a bit quicker so it is a nice option that allows this to produce up to 20 gallons of hot water per hour.
Ten gallon capacity. 10,000 BTU. Atwood water heaters are designed so that more than 90% of the heat produced by the pilot light is utilized to maintain water temperature eliminating much energy waste. Atwood’s heat transfer system with patented U-tube design delivers more hot water.
It has an engine heat exchanger which actually heats view full answer… The heating element on your Atwood model GC10A-4E water heater (our part # AT94022) should be on the backside of the unit, towards the bottom of the tank.
Where can I get an Atwood RV serviced?
Service for all Atwood products is handled out of our Rockford location. Should you have any questions regarding our products or the information contained in this manual simply dial 1-800-825-4328. Be sure to have the Model and Serial Number when you call. Atwood Service Department
