What is standby mode on pool heater?
STANDBY: in this mode, the heater will not function to heat the water. 2. SPA: in this mode, the heater will automatically function to maintain the water temperature setting for SPA mode. To adjust the temperature while in SPA or POOL mode, use the UP and DOWN buttons.
Why does my Raypak pool heater not ignite?
Now the ignite will spark (with the code on the unit as SPK), but even with a lighter, the unit does not flame up. I suspect that there is no gas going to the burners. Anyone have similar issues? Could it be the gas regulator (I’ve turned it off and on many times), or a clogged gas line. Of course, we have company coming over tomorrow!
What are the requirements for a Raypak pool heater?
Raypak pool & spa heaters are built for outdoor installations as standard. The installation must conform to AS5601 OR AS/NZS 5601.1 as a minimum. They must not be installed in any enclosed structure or under eaves, roof overhangs, or pool decks.
What to do if your pool heater keeps turning off?
If your pool heater keeps turning off and on, check to see if the water flow light on the display is lit up. If your unit doesn’t have this light, then walk over to your filter pump and check the pressure.
Can a pool heater be installed under a roof?
They must not be installed in any enclosed structure or under eaves, roof overhangs, or pool decks. Outdoor pool & spa heaters must be installed at least 1500mmfrom any window or room ventilation opening. They must also have no obstructions above the appliance.
How to check for gas leak in Raypak pool heater?
¾DO NOTtry to light this appliance. ¾DO NOTtouch any electrical switch. ¾TURN OFFthe gas supply at the meter immediately, contact an qualified gas fitter or Rheem Service. Note:Some gases are heavier than air and it may be necessary to check for gas leaks at floor level. Ceramic Fire tile refractory is used in this appliance.
How does a Raypak pool and spa control work?
2) If three lockouts occur in one heat demand, control goes into “hard lockout” and power must be removed and re-applied to reset. Your heater is equipped with a microprocessor-controlled thermostat that controls the pool or spa temperature by measuring the temperature of the water coming back through the heater.
What to do if your Raypak rp2100 heater goes out?
Turn gas control knob counter-clockwise to “Pilot” 9. Place flame to end of pilot tube. Push in control knob all the way and hold to light pilot. Continue to hold control knob in for about one minute after the pilot is lighted, release knob and it will pop back up. Pilot should remain lighted. If it goes out, repeat steps 5 through 9.
What kind of refractory is used in Raypak pool heater?
Ceramic Fire tile refractory is used in this appliance. For a current Material Safety Data Sheet (MSDS) go to and enter “MSDS 354” in the search. Ceramic Fire tile refractory may produce smoke when the appliance is first started.
